EZTRUNK 1900 0096 User manual

BEFORE BEGINNING,SEE THE ASSEMBLY INSTRUCTION VIDEO ON EZTRUNK.NET
Alumium EZ Table for Tire
Ver A_8/04/22
CUSTOMER SERVICE: [email protected]
Text & Call : 203-901-0055 / Call 203-591-9060
Page 1
PO#
:
Print the latest manual &
Watch the EZTRUNK Video
Scan QR CODE for Video &
PDF MANUALS
MAKE IT
MAN
U
A
L
A
SS
EMBL
Y
WE CAN HELP YOU!
Customer Service
Any question? WE ARE HERE TO HELP!
EMAIL US: [email protected]
Text or Call 203-901-0055 / Call 203-591-9060
7 days a week 8:30 am EST
Aluminum EZ Table for Tire
#1900 0096

BEFORE BEGINNING,SEE THE ASSEMBLY INSTRUCTION VIDEO ON EZTRUNK.NET
Alumium EZ Table for Tire
Ver A_8/04/22
CUSTOMER SERVICE: [email protected]
Text & Call : 203-901-0055 / Call 203-591-9060
Page 2
Please read instructions fully before beginning assembly
NO Illustration Description Part# QTY.
1EZ Table 19000096 1
2 Tire Support Bar 1900009601 1
Pre Installed
3 Short Leg-Left 1900009602 1
Pre Installed
4 Short Leg-Right 1900009603 1
Pre Installed
5 Long Leg 1900009604 1
Pre Installed
6Thumb Turn Bolt 06081 3
Pre Installed
7 Webbing Strap 1900009605 1
Pre Installed
Diagram (1) see double arrows in photo --press silver buttons to release short legs
from table (slide out).
1
Diagram (2) Insert short legs into the square holes on table.
Loosen the thumb turn bolts #1 (left & right sides) to pull out the tire support for
securing to tire.
Press silver button on long leg.Turn thumb bolt to loosen & adjust leg to desired
length.
2
#1
#1
WARNING:
EZ Table is NOT to be used as a step, or seat. Using the table as either could result in bodily injury or damage to table.
ALWAYS remove table before driving.
EZ Table Max load capacity is: 50lbs(when table is installed properly)

BEFORE BEGINNING,SEE THE ASSEMBLY INSTRUCTION VIDEO ON EZTRUNK.NET
Alumium EZ Table for Tire
Ver A_8/04/22
CUSTOMER SERVICE: [email protected]
Text & Call : 203-901-0055 / Call 203-591-9060
Page 3
Diagram (3) Place table over tire. Hold table in place with pressure and hand pull
the support bar towards you to make a secure tight t. Then tighten the thumb bolt
on each side of table.
3
Diagram (5) Loosen the thumb turn bolt on center leg and adjust accordingly to the
correct height. Tighten bolt to secure. Test stability & positioning by pushing down
on all four corners. Table should not move and be secure.
5
Diagram (4) Take hook side of webbing and feed through Hole #1 & #2 hooking
onto Hole #3. Then adjust webbing tight with fasten to secure tightly to the vehicle
tire.
4
Pull the bottom of buckle to release the hook. Follow opposite steps to remove the
EZ table from tire.
6
Hole #3
#2
#1
WE CAN HELP YOU!
Customer Service
Any question? WE ARE HERE TO HELP!
EMAIL US: [email protected]
Text or Call 203-901-0055 / Call 203-591-9060
7 days a week 8:30 am EST