Faber 5980411 User manual

For recirculating installations, high
quality, heavy duty filters ensure
the removal of smoke and odors
from the kitchen. Some ductwork is
required to exhaust the unit out of
the cabinet.
Charcoal Filters 6093034
Choose from a white, black, or
brushed aluminum front strip (all
are included in the box). For a
totally integrated look, the front
strip can also be replaced with a
custom built strip to match your
cabinets. See reverse for front
strip dimensions.
For a streamlined look in the kitchen, the Cristal HC is your
integrated solution. The Cristal HC has a sleek pull-out visor
which slides in, flush with your cabinets, neatly tucking the
hood away. For total integration, the front strip can be
replaced with material to match your cabinets, hiding the
hood completely.
slideout rangehood
slim styling
microswitch turns motor/lights on
when pulled out
closes flush with cabinets
easily replaces existing hoods
500 cfm
1 glass covered fluorescent light
3 speed control
dishwasher safe grease filters
convertible to recirculating
top or direct rear venting
built-in mounting system
sone range: 3.5 - 6.5
6” round duct
Size/Color/Model #
30 *
36 *
* white, black and brushed aluminum
front trims come with every Cristal HC
in the box
°
°
°
°
°
°
°
°
°
°
°
°
°
°
5980410
5980411
a
c
c
e
s
s
o
r
i
e
s
p.o. box 435 • Wayland, MA 01778 • tel: [phone] • fax: [phone] • e-mail: [email protected] • www.faberonline.com
Cristal HC
powerful, practical, pretty
Integrated Collection

Side View
Cut-Out
Bottom View
Note: The Cristal HC comes standard in the top vent
position. The direct rear vent position can be achieved
by rotating the blower
housing.
Dimensional Diagrams
Rev.06/08
WARNING! Product specifications are subject to change without notification. Consult the installation instructions
before you begin installing this rangehood.
Custom Front Panel Dimensions
Make your ductrun as straight and
short as possible. The ductrun
should not exceed 35 equivalent feet
if ducted with the required minimum
of 6” round duct. Count 45º angles
as 3 feet, 90º elbows as 5 feet, and
90º flat elbows as 12 feet.
For best results, use no more
than three 90° elbows. Make sure
that there is a minimum of 24”
of straight duct between elbows
if more than one is used. Do not
install two elbows together. If you
must elbow right away, do it as
far away from the hood’s exhaust
opening as possible.
For more efficient airflow when
venting to the rear: Rotate the
Cristal HC blower housing so that
the 6” round exhaust outlet faces the
back, rather than running ductwork
up and elbowing back.
Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood.
Recirculating Installations
Some ductwork must
be installed to exhaust
the rangehood back
into the kitchen, either
at the top of the
cabinet or at the face
of the soft. A plastic
vent grate supplied
with the rangehood
can be used to cover
the duct opening. This
duct work must not
terminate into a dead
air space.
Front View
For installations where ductwork to the outside of your home is impossible or highly impractical
Charcoal Filters, which attach to the blower assembly, absorb smoke and odors.
cabinet
ceiling
6” round
duct
hood
cabinet
ceiling
6” round
duct
hood
soft
vent grate
vent grate
29 7/8” or 35 7/8” 3/4”
1 15/32”
Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing
this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24” and a maximum of 30”
for maximum effectiveness. Also consult the cooktop manufacturer’s recommendation.