FANATEC ClubSport Porche 918 RSR User manual

SHIFTER CALIBRATION
TUNING OPTIONS
In order to enter shifter calibration mode, simultaneously
press the Tuning Button and the button highlighted below.
In order to enter Tuning Menu, press the Tuning button.
In order to navigate inside the menu, use the right
FunkySwitch™. Press it up or down to access 5 setups.
Press the FunkySwitch™, right or left, to go through the
options and turn the FunkySwitch™ to change option
values.
Tuning Button
Tuning Button
FunkySwitch™
MODE
CENTRE CALIBRATION
BUTTON MAPPING
In order to switch between modes, simultaneously press
and hold the two buttons highlighted below for one second.
The wheel base LED indicates the active mode:
● Red indicates PC mode
● Blue indicates PS4™ mode*
● Purple indicates compatibility mode*
If a centre calibration is needed
(e.g: after rmware update of
ClubSport Wheel Base) when
using the steering wheel you
need to enter the Tuning
Menu by pressing the Tun-
ing Button.
When the Tuning Menu is
active, press the analogue
stick and the FunkySwitch™
at the same time as illustrated
on the right in order to calibrate
the wheel centre.
Tuning
Button
1
D-Pad + 24 22 23
PS
21
SHARE
8
2
3
R1 4
0
L1
5
R2
6
L2
7
N/A
25
L3
11
R3
10 OPTIONS 9
EN
Quick Guide
www.fanatec.com
* Not applicable for every Fanatec wheel base.
Please check the individual user manual of
your Fanatec wheel base.

ATTACHING THE STEERING WHEEL
- Remove storage pin
- Pinch and hold
Quick Release mechanism
A
- Slide Rim off ClubSport Wheel Base axle
Detail A
- Place Rim face down on table
- Insert storage pin
- Align ClubSport Wheel Base axle,
to correct position
- Press togther or “pinch”
and hold Quick Release
mechanism
- Slide Rim onto ClubSport Wheel Base axle
- Now release the sleeve of the
Quick Release mechanism
- Now release the sleeve of the
Quick Release mechanism
DETACHING THE STEERNIG WHEEL SHIFTER PADDLE OPTIONS
Make sure the newest CSW Base rmware le has
been downloaded. You can obtain it at Fanatec’s
website (www.fanatec.com) in the download section.
Fanatec®is a registered trademark of Endor AG
Designed and developed by Endor AG in Germany
Manufactured by
E.ON-Allee 3 - 84036 Landshut - Germany
Telephone: [phone] Fax: [phone]
Email: [e-mail]
Website: www.fanatec.com - www.endor.ag