Fantech Ezifit Thru Roof ERV200 User manual

Part No.: INST-ERV200 08/12 Page 1 of 3
Ezifit Thru Roof
Relief Vent
Ø200mm Spigot
CONTENTS & INSTALLATION INSTRUCTIONS
Contents:
Ezifit Relief Vent 1 off.
Roof Flashing-Metal Deck 1 off.
Roof Flashing-Tile 1 off.
Mounting Brackets 2 off.
Installation Instruction 1 off.
Mounting Screws 12 off.
also available on request;
Flexible duct 200 dia. x 6m long DUCT200-6M 1 off.
Internal ceiling exhaust grille ALG200 1 off.
Inspection:
Ensure the unit hasarrived in good condition.
This product is designed to be installed on a roof up to 45°pitch.
Installation on Metal Deck:

Part No.: INST-ERV200 08/12 Page 2 of 3
Installation on Metal Deck:
1. Installation of this product should be carried out by appropriately qualified persons.
2. Cut a hole in the roof 200mm minimum(with regard to roofpitch angle) diameter. The hole shouldbe
positioned adjacent to a rafter or other member to facilitate the use of the mounting brackets supplied.
Ensure a clean edge.
3. Cut the rubber roof flashing supplied for190mm diameter through roof duct.
4. Slide the flashingover thethrough roof duct to the required position.
5. Check the fit of the duct in the cut hole. The duct must be positioned vertically.
6. If satisfactory fasten the duct to the rafter or other member using the mounting brackets provided.
7. Fit the flashing tothe metaldeck using the mounting screws provided. Seal duct seam with sealant.
8. The vent through roof duct is designed for connection to 200mm duct usingduct tape or clamps.
Installation on Tiles:
Installation on Tiles:
1. Installation of this product should be carried out by appropriately qualified persons.
2. Prepare an opening in the tiled roof 220mm minimum (with regard to roof pitch angle) diameter. The
hole should be positioned adjacent to a rafter or other member to facilitate the use of the mounting
brackets supplied.
3. Cut the rubber roof flashing supplied for190mm diameter through roof duct.
4. Slide the flashingover thethrough roof duct to the required position.
5. Check the fit of the duct in the opening. The duct must be positioned vertically.
6. If satisfactory fasten the duct to the rafter or other member using the mounting brackets provided.
7. Fit the upper edge of the flashing underneath the tile, bending over top edge to form an anti-capillary
barrier.
8. Cut two tabs in the cornersof the lower sectionand turn under tile (refer detail). Lay the lower section
of the flashing over tiles and form a run off tray. Form to tiles. Seal duct seam with sealant.
9. The vent through roof duct is designed for connection to 200mm duct usingduct tape or clamps.

Part No.: INST-ERV200 08/12 Page 3 of 3