Feelgood PY7 User manual

Page 1 of 6
3X6M GREENHOUSE-- PY7
PART LIST
DIMENSION
QUANTITY
NO.1·
1436MM
16
BOX-1
NO.2
1436MM
4
BOX-1
NO.3
1110MM
6
BOX-1
NO.4
1110MM
4
BOX-1
NO.5
1080MM
10
BOX-1
NO.6
670MM
4
BOX-1
NO.7
670MM
6
BOX-1
NO.8
1263MM
2
BOX-1
NO.9
775MM
4
BOX-1
NO.10
1170MM
8
BOX-2
NO.11
1055MM
2
BOX-2
NO.12
994MM
1
BOX-2
NO.13
994MM
1
BOX-2
NO.14
994MM
1
BOX-2
NO.15
994
1
BOX-2
NO.16
710MM
1
BOX-2
NO.17
330MM
A
B
A 1
B 1
BOX-2

NO.18
1445MM
1
BOX-2
NO.19
1445MM
1
BOX-2
NO.20
1335MM
1
BOX-2
CONNECTER AND ACCESSORIE SHEET
Number
QUANTITY
Number
QUANTITY
NO.21
2
BOX-2
NO.22
3
BOX-2
NO.23
4
BOX-2
NO.24
6
BOX-2
NO.25
6
BOX-2
NO.26
4
BOX-2
NO.27
4
BOX-2
NO.28
28
BOX-2
NO.29
14
BOX-2
NO.30
1
BOX-2
NO.31
1
BOX-2
NO.32
COVER SET
1
BOX-2
NO.32
1
BOX-2
Page 2 of 6

STEP I - Lay all roof parts (1, 5, 6 and 7) flat on the floor and connect like below with part 21, 22, 23, 24.
Page 3 of 6

STEP II –Inserting legs
Lift up one side insert tube No.3 and No.4, leg 4 at both ends, leg 3 in the middle.
STEP III
Repeat step II lift up and install the other legs.
STEP IV Create ground frame
Page 4 of 6

STEP V Assemble the door frame like the diagram, secure the corners of the door frame using the door cable set.
Pull the door cover onto the door frame and seal it with the velcro.
STEP VI Attach the door lock. Make a small hole through the fitted door cover to match the hole that is pre drilled on
the door (Tube No.15), make it small enough so just a screw can fit through. Next thread through the locking screw
and tighten use screw M6X37.
STEP VII Screw tube 12,13, 14, and 15 to tubes 6, screw bolt in from the other side of tube 8 (Use screw M6X40)
STEP VIII –Position and screw bracing bars (10 and 11) into place –see first diagram to view all positions. (Use screw
M6X40)
Page 5 of 6

STEPVIII
Pull the greenhouse cover over the main frame and secure the cover to the frame by using the Velcro
STEPIX
Side water collector. Use and adjust the buckle ties on the waterspout fabric to make it gather water when is
needed.
Page 6 of 6