Feelgood 2X3M MEDIUM CAGE User manual

2X3M MEDIUM CAGE
CAGE 2M
PART LIST
DIMENSION
QUANTITY
NO. 1
997MM
4
Box - 1
NO. 1a
999MM
4
Box - 1
NO. 2
997MM
2
Box - 1
NO. 2a
999MM
2
Box - 1
NO. 3
1080MM
4
Box - 1
NO. 4
1128MM
4
Box - 1
NO. 5
1263MM
4
Box - 1
NO. 6
775MM
4
Box - 1
NO. 7
1170MM
8
Box - 1
NO. 8
425MM
1
Box - 2
NO.9
1000MM
1
Box - 2
NO.10
1000MM
1
Box - 2
Page 1 of 7

NO.11
1000MM
1
Box - 2
NO.12
1000MM
1
Box - 2
NO. 13
400X800MM
2
Box - 2
LOCK
2
Box - 2
CONNECTER AND ACCESSORIE SHEET
NUMBER
QUANTITY
14
8
Box - 1
17
4
Box - 1
18
4
Box - 1
24
Box - 2
16
Box - 2
WIRE MESH -
DIMENSIONS:1.1X13M
2
Box - 2
CABLE TIE
1X20M
Box-2
ROOF COVER AND ACCESSORY Following parts are for the optional cover
ROOF COVER
1
26
Roof support Bar
1
BOX-1
Page 2 of 7

We advise having cable ties available to help keep wire mesh in place when you are fitting it.
Page 3 of 7

SET UP AS BELOW ILLUSTRATION
STEP I – The roof components are to be built first, poles 1, and 1a, make up the sides, with poles 4 and 5 making up the front and back.
Lay all roof parts on the floor and connect like below with part 14.
Page 4 of 7

STEP II –Inserting legs
Lift up one side insert tube No.3, place part no 17 on the end of each leg.
STEP III
Repeat step II lift up and install the other legs.
STEP IV – Create ground frame
Install ground tubes as below illustration, once completed the bracing bars(part 7) can be fixed from each leg, see complete picture on page 3 for positioning.
Page 5 of 7

STEP IV Install door to main frame as below Illustration.
Screw tube 9, 10, 11,12 to the frame, the poles already contain threads to take the screws. Please screw from the top of the frame
and from underneath the frame in line with holes on tube 5, screw tube 8 in the same way.
STEPVI
Link the net as below illustration, and put cover on last. Cable tie the sections of mesh to the frame before cutting to size. The long
wire threads can be used to lace over lapping parts of the mesh together or further secure the mesh to the edges of the frame.
Page 6of 7

STEPVII
Roof support bar installation as below illustrations.
CONSTRUCTION WARNING – MUST BE FOLLOWED TO AVOID DAMAMGE WHEN USING THE OUTDOOR COVERS.
Because of the flat roof the wire mesh must be pulled as tightly as possible across the top and secured around the top edge with
cable ties. This will stop any ‘give’ in the mesh and stop water building up on the cover which may cause damage to the cover or
supporting poles.
Where the mesh overlaps this should also be fixed together at the tightest point with cable ties to stop water being able to build up.
Page 7of 7