Feelgood CAGE 6M User manual

3X6M EXTRA LARGE CAGE
CAGE 6M
PART LIST
DIMENSION
QUANTITY
NO. 1
1263MM
26
Box - 1
NO. 2
1263MM
4
Box - 1
NO. 3
1080MM
4
Box - 1
NO. 3a
1080MM
8
Box - 1
NO. 4
1128MM
12
Box - 1
NO. 5
1263MM
4
Box - 1
NO.5a
1263MM
4
Box - 1
NO. 6
775MM
4
Box - 1
NO. 7
1170MM
8
Box - 1

NO. 8
425MM
1
Box - 3
NO.9
1000MM
1
Box - 3
NO.10
1000MM
1
Box - 3
NO.11
1000MM
1
Box - 3
NO.12
1000MM
1
Box - 3
NO. 13
400X800MM
2
Box - 3
LOCK
2
Box - 3
DOOR SPINDLE
(2 PCS M6X30 SCREW MATCH
WTH ONE SPINDLE)
4
Box - 3
CONNECTER AND ACCESSORIE SHEET
NUMBER
QUANTITY
NUMBER
QUANTITY
14
8
Box –3
15
16
Box - 3
16
8
Box - 3
17
4
Box - 3
18
4
Box - 3
19
32
Box - 3
20
24
Box - 3
21
Plastic tie
300
Box - 3
WIRE MESH (box 2)
2
DIMENSIONS:1.1X20M
ROOF COVER AND ACCESSORY Following parts are for the optional cover
ROOF COVER
1
26
Page 1 of 6
Page 2 of 6

We advise having cable ties available to help keep wire mesh in place when you are fitting it.
Page 3 of 6

SET UPAS BELOW ILLUSTRATION
STEP I –The roof components are to be built first, poles 4 make up the sloped sides running front to back, with poles 5 and 5a making up the central, flat horizontal row, poles 1 run from
front to back like below diagram.
Lay all roof parts on the floor and connect like below with part 14 and 15
Page 4 of 6

STEP II –Inserting legs
Lift up one side insert tube No.3 and No.3a, leg 3 at both ends, leg 3a in the middle.
STEP III
Repeat step II lift up and install the other legs.
STEP IV –Create ground frame
Install ground tubes as below illustration –part no 7 (bracing bars) can now be fixed in each corner (see earlier picture)
Page 5 of 6

STEP IV Install door to main frame as below Illustration.
Screw tube 9, 10, 11,12 to the frame, the poles already contain threads to take the screws. Please screw from the top of the frame
and from underneath the frame in line with holes on tube 5, screw tube 8 in the same way.
STEPVI
Link the net as below illustration, and put cover on at last.
Page 6 of 6

CONSTRUCTION WARNING –MUST BE FOLLOWED TO AVOID DAMAMGE WHEN USING THE OUTDOOR COVERS.
Because of the flat roof the wire mesh must be pulled as tightly as possible across the top and secured around the top edge with
cable ties. This will stop any ‘give’ in the mesh and stop water building up on the cover which may cause damage to the cover or
supporting poles.
Where the mesh overlaps this should also be fixed together at the tightest point with cable ties to stop water being able to build up.