FeiYu Tech MG Lite Quick start guide

Guilin Feiyu Technology Incorporated Company
Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com [email protected]
- 1 -
MG Lite / MG V2 Gimbal Firmware
Upgrade Manual
Attention :
Please install the batteries before firmware upgrade.
The firmware upgrade software only supports the Windows operation system
provisionally.
Please operation step by step strictly and make sure click the ―OPEN‖ button
to open the com port before the USB mini terminal of the USB cable connect to
the gimbal.
If you want to get the current version of the gimbal, please execute step 1~6.
1. Download the USB driver from FY-TECH official website and install. Then
download the dedicated firmware upgrade software and the firmware for
Gimbal-Update-3AXIS gimbal.
2. After successful install the USB driver, please refer to the above connection
diagram, connect the USB cable to the USB connecter then insert the USB
connecter to the computer. Confirm the port number in device manager (If the
port number is more than COM10 , please modify to the available number
which less than COM10 ).
3. Open the software ——―Gimbal-Update-3AXIS‖.

Guilin Feiyu Technology Incorporated Company
Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com [email protected]
- 2 -
4. Software interface is shown in following picture.:
5. Choose the correct port number and the correct baud rate-115200, then click
OPEN button to open the com port.(The serial port number should be the
same as the port number which checked in step 2).
6. Long press the function button for and release it until the green light is on .
After connect successful, the software will reminder the connection status and
read out the current version (For example ―LINK OK! VERSION 1. 44‖)

Guilin Feiyu Technology Incorporated Company
Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com [email protected]
- 3 -
7. Click on OPEN FILE button and choose the correct firmware for the MG
Lite / MG V2.
8. Click on UPDATE button to start upgrading, the process will display on the
software.
9. Data of firmware being sent to the MG Lite or MG V2 completely, please click
―Confirm‖ button to finish the upgrade. Close the software then remove the
USB cable.

Guilin Feiyu Technology Incorporated Company
Guilin Feiyu Technology Incorporated Company www.feiyu-tech.com [email protected]
- 4 -
–––– END ––––
Note: We reserve the right to change this manual at any time!And the newest edition will
be shown on our website www.feiyu-tech.com.