Fender HAMMERTONE FUZZ User manual

INPUT JACKOUTPUT JACK
9V BATTERY SCREW ACCESS ON REAR
DC POWER CONNECTOR
FOOTSWITCH
LED

Thanks for purchasing the Hammertone Fuzz—a
classic stompbox effect that drives your sound to
new heights of gritty satisfaction.
Dial in all the fuzz desired with tone, fuzz, gain
and level controls, and use the internal trim
potentiometer to tailor the tonal breakup even
more. Fuzz is an perennially cool effect in the
arsenal of any guitarist and bassist, and the
Hammertone Fuzz puts the buzz at your feet in
every shade from slight to super.
HAMMERTONE FUZZ

OUTPUT JACK
Low-impedance output connects to amp or next pedal in signal chain.
INPUT JACK
High-impedance input for electric guitar, bass, acoustic guitars with
pickup systems, keyboards and other instruments.
DC POWER CONNECTOR
Connect DC adapter here. Standard center-negative 9VDC jack for use
with appropriate power supplies.
TONE CONTROL KNOB
Adjusts balance between treble and bass frequencies.
FUZZ CONTROL KNOB
Adjusts amount of fuzz.
LEVEL CONTROL KNOB
Adjusts output volume of effect.
OCTAVE SWITCH
Adds octave-up fuzz mode, providing more volume and cut.
LED
Illuminates when effect is on.
FOOTSWITCH
Turns effect on and off.
BATTERY COMPARTMENT (REAR)
Screw-access compartment houses one 9V battery.

INTERNAL TRIM POTENTIOMETER (ACCESSIBLE BY
REMOVING COVER)
TONE 2 trim pot adjusts high-frequency character.
Remove cover using a flat-head screwdriver. Adjust trim pot using a
Phillips-head screwdriver.
TONE 2 TRIM POT
9V BATTERY
(NOT INCLUDED)

A PRODUCT OF
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA, U.S.A.
Fender®is a registered trademark of FMIC.
Copyright © 2021 FMIC. All rights reserved.
PN 7724432000 REV A
IMPORTANT SAFETY INSTRUCTIONS
•WARNING: To prevent damage, fire or shock hazard, do not expose the unit or its AC
power to rain or moisture.
•Do not alter the AC plug of the connected power adapter
•Do not drip or splash liquids on the unit.
•No user serviceable parts inside, refer servicing to qualified personnel only.
•WARNING: The unit must only be connected to a safety agency certified, regulated,
power source (adapter), approved for use and compliant with applicable local and
national regulatory safety requirements.
•Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth
for cleaning and then wait until the unit is completely dry before reconnecting it to power.
•Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable
of producing very high sound pressure levels which may cause temporary or permanent
hearing damage. Use care when setting and adjusting volume levels during use.
ADDITIONAL LANGUAGES
Manual available in additional languages at
www.fender.com/support
Product specifications subject to change without notice
SPECIFICATIONS
IMPEDANCES
POWER SUPPLY
POWER REQUIREMENTS
DIMENSIONS
WEIGHT
Input: 500kΩ Output: 5kΩ (max)
9VDC regulated adapter,
5.5 x 2.1 mm barrel connector, center negative
80mA @ 9VDC
2.44” x 4.4” x 2.2” (62mm x 111.8mm x 55.9mm)
0.55 lbs (0.25kg)

© FENDER MUSICAL INSTRUMENTS 2021