ferm living PEKA User manual

PEKA BENCH
ASSEMBLY MANUAL
fermliving.com
7. The Peka Bench is now ready for use.6. Spread out a rug/towel on the ground to protect the
bench. Then, carefully place the Peka Bench on its back.
Attach all seven of the small wooden screws into the
corresponding holes on the underside of the seat.
6. 7.

NEEDED FOR ASSEMBLING
Two people
A rug/towel to protect
the bench when placing it
on the ground
2.a. Place the backrest onto the legs.
2.b From the bottom, screw two 20 mm screws into the
backrest. Repeat the process for the other leg.
3. Take the two machine screws and screw them into the
legs and backrest as shown.
4. Attach seat - Part A using two of the long
wooden screws.
5. Attach seat - Part B using two of the long wooden
screws. Make sure to match up the protruding dowels
with the indentations in seat – Part B.
2.a
2.b 3.
4. 5.
4 x long wooden screws
2 x machine screws
7 x small wooden screws
4 x 25 mm screws
4 x 20 mm screws
2 x legs
1 x backrest with shelf
1 x seat Part A
1 x seat Part B
2 x metal plates
1. Place the two legs upright. Attach one metal plate to
each leg using two 25 mm screws. Remember to place
the metal plate as shown in the close-up.
1. Close-up