Ferm PORTI User manual

PORTI LAMP
ASSEMBLY MANUAL
fermliving.com

Voltage:
Cable:
Dimmable:
Light Specification:
Energy Class:
Battery capacity:
Certification:
Recommended Light source:
Recommended adapter:
5V DC (Lamp input)
5%-100% touch dimming
2W, 3V DC
2700K
50lm Max
G
3,7V, 5000mAh, Lithiumion rechargeable Charging
time 5 hours
Discharging time 12 hours (max power)
CE/UKCA/CB/ETL/SAA/RoHS
Non-removable LED
100-240V 50/60Hz input, 5V/2A output
(Adapter not included)
PORTI LAMP
TECHNICAL SPECIFICATIONS
WARNING:
The safety of this fitting can only be guaranteed if the following instructions are observed during both
installation and use. Please retain these instructions safely after installation.
Please observe the following guidelines:
- Ensure that the power supply has been switched off prior to installation or removal of the product.
- Never undertake an electrical installation without the proper knowledge or training. If not familiar
with electrical wiring, contact a qualified electrician.
- The product may in no way be modified or tampered with. Any modification may compromise
safe-ty and make the product itself dangerous to use. FERM LIVING does not accept any
responsibility for products that have been modified.
-The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person.
- This product is meant for dry location use only.
CLEANING INSTRUCTIONS:
- Use only a soft cloth to clean the product. Dampen the cloth with water and soap or a mild cleanser
if needed.
MORE INFORMATION:
To access further information such as product overview and material descriptions, please visit our
website at www.fermliving.com if you have any questions or comments, please do not hesitate to
contact us at [email protected].
Please read before installation
GENERAL INSTRUCTIONS

1
2
1. Insert usb-c cable at the bottom for charging the lamp.
2. Quick tap at the lamp bottom to simply turn on/off the lamp. (it remembers the brightness from
last time when it’s turned off.)
Quick Tap
On/Off
x1
Lamp
x1
USB-C cable
BOX CONTENT

5. Adjust the lamp feet by screwing them forward or backward.
53
4. Mode 1: Dim the lamp to maximum, and hold still 1 sec for 100% light on the top and 20% under.
Mode 2: Dim the lamp to minimum, and hold still 1 sec for 20% light on the top and 100% under.
4
3. Dimming up: Touch the lamp bottom and hold still, it gives a blink when it reaches 100% brightness.
Dimming down: Remove hand and touch it again hold still, it gives a blink when it reaches 0% brightness.
Hold still.
Dimming
up & down
Tap hold.
Mode 1,
Mode 2
100%
MODE 1 MODE 2
20%
20%
100%
DIM
100%
0%
100%
MODE 1 MODE 2
20%
20%
100%
DIM
100%
0%