Fetco L3D-10 Operating instructions

HOW TO USE YOUR LUXUS® THERMAL DISPENSER
To open the dispenser, first unscrew the plug on the top by
turning it counterclockwise till it stops.
Next, grasp the top of the handle from the front and pull it
down completely toward you.
The dispenser is now open and ready for brewing.
To close the dispenser, move the plug and swing arm into
position with the dispenser opening.
Move the handle to its upright position. Be sure that the
handle is straight up-and-down.
Screw down the plug tightly to prevent any spillage while
carrying. The dispenser may now be transported to any
remote location.
Preheating or precooling of the dispenser is highly recommended. Before the first brew of the
day, fill the dispenser at least ½ way with water from the brewer. Let the water sit inside for 5-10
minutes, then drain out completely.This will extend the time that the beverage can be served at
optimum temperature.
FETCO, LUXUS, Extractor, Millenia, Pulse-Brew are all trademarks or registered trademarks of FETCO.