Filmcity BELLY CRUZER DSLR STEADY CAMERA RIG Quick start guide

All rights reserved
No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, except as may be expressly permitted
by the applicable copyright statutes or in writing by the Publisher.
Setup and Operational Manual
BELLY CRUZER–DSLR Steady
Camera Rig
(FC-BC-DSR)

FILMCITY BELLY CRUZER DSLR STEADY CAMERA RIG 2
I N T R O D U C T I O N
Keeping pace with the advancements in today's DSLR and Camcorder technology, Amazingly ad-
vanced and totally re-engineered BELLY CRUZER DSLR STEADY CAMERA RIG from FILMCITY
represents lightweight and state-of-art Rig. A lightweight, modular soluon that is designed to be
mobile and exible so you can capture your footage smoothly, the way you want it to be seen.
I N T H E B O X
Please inspect the contents of your shipped package to ensure you have received all that is
pictured and listed below.
MB-600 Mae Box
Top Plate
Base Plate
Top Handle
Handle Set
Belly Support
Shoulder Pad
Baery Mounng Plate
Handle Bracket
Front Handle Bracket
Accessories
AD-15 Adapter
5x 300mm female rods
4x 250mm female rods
2x 300mm male rods

FILMCITY BELLY CRUZER DSLR STEADY CAMERA RIG 3
A S S E M B LING YO U R M B -6 0 0 M AT T E BOX
 Insert the French flag in to the Matte Box and tighten the screws. Using the
same approach, insert the side flags into the (big) slots provided in the hinges
and secure with the screws.
 Insert the filter holders to your matte box as shown below.
Note: For better gripping of filter in filter holder, retighten the filter tray knob to
secure the filter properly.
Note: If the French flag (top)
remains loose even after tightening
the knob you have to slightly tighten
the allen bolt as shown in the image.

FILMCITY BELLY CRUZER DSLR STEADY CAMERA RIG 4
 Aach Base Plate to your tripod plate and ghten it with help of screw driver. Now aach
set-up to your tripod stand and ghten with provided knob to ensure slip free connecon.
 Aach quick release plate to camera base and secure with screw driver. Now mount your
camera set-up onto tripod and secure with provided knobs.
 Remove quick release plate from base
plate by loosening provided knob and
pushing buon.
 Attach knicker on conversion ring, then screw in the conversion ring on ring
holder.

FILMCITY BELLY CRUZER DSLR STEADY CAMERA RIG 5
 Insert 2x 300mm female rods to back of base plate, then aach belly support to it and
ghten properly.
 Insert 4x 250mm female rods onto base plate and ghten knobs to secure.
 Now aach top plate onto the rods
and ghten with provided knobs.
 Aach quick release plate to camera base and secure with screw driver. Now mount your
camera set-up onto tripod and secure with provided knobs.