FireBlitz FH700HIA Instruction Manual

Installation and
Maintenance
Firehawk Deaf Alert

Component Parts
FHB10W Smoke
Alarm
Carbon Monoxide
Alarm

Separate Control Centre
from Backplate
Remove Connection
Cover
Pass cables through Back
plate and into Control Unit
Fit Control Centre
onto Backplate or
Stand
Assembly and Testing

Bring together
and …
Step 5
FH700HIA Assembly, pairing and Testing 24-3-18
Do NOT
connect
anything to
these two
pins.
Plug in the power lead and
the power transformer into a
13amp socket and turn on
Plug in the
Vibrating Pad
Take alarms to their
working location and
press their pairing
button
Step 1 Step 2 Step 3 Step 4
……. within 15 Seconds of
pressing the pairing button
Assemble the alarm
within 15 seconds of
pressing the pairing button !
Each alarm will beep twice
at the START of pairing
Repeat steps 3 to 5
for each alarm in the system,
one after another.
Each radio base will flash a
green LED once per second
during pairing
Step 6
Press the learn button
on the Control Centre Step 7
Wait for each alarm …..
1. To beep twice at the
END of pairing
2. To flash the green LED
once per minute on all
devices including the
Control centre
3. Test the complete
system from every
device
Plug in
alarm
and ….
Switch on
the radio
base

Final Installation
Refit the Connector cover with
its screw.
Re-assemble The control Centre
to its stand or backplate
1. Locate Control Centre Where the Strobe can be seen by the end user
2. Locate Vibrating Pad in suitable position to be able to wake a person –
for example under a pillow or touching their body in a chair

Power = Brief Red flash every minute followed by a
Single beep after 10 secs if the battery power is weak
Alarm = Repeating Red flashing light twice every second
+ a series of 3 beeps every 4 seconds
Fault = Double Bleep every minute
Test Button Jammed = Single beep every 11 seconds
Test = Repeating Red flashing light twice every second
+ a series of 3 beeps
Lights and Sounds –
Smoke Alarm
Alarm Silence = Brief Red flash every 10 Seconds
Lights and Sounds –
Deaf Alert
Power = Brief Green Flash every minute.
Alarm = Flashing Red Fire of CO light + Flashing Strobe light +Vibrating
Pad + Alarm sound from the Fire and Carbon Monoxide Alarms
Test = All four lights show one after another followed by flashing from the Strobe,
vibrations from the Pad and an alarm sound from the Fire and Carbon Monoxide
Alarms
Fault = Yellow light every minute
Pairing = Double Bleep at the start and end of pairing

General Notes
1. Up to 14 Heat or Smoke Alarms can be connected to the system.
2. The system has a back-up battery so if it is necessary to move to
another room during the day , just un-plug from the wall socket and
take the complete system with you. Always plug back into the mains at
night to re-charge.
3. Always test the system at least once a week.
4. If you wish to add further alarms to an existing system, power down all
existing Alarms and Control Centres and re-learn with the additional
alarm(s) as shown from slide 5 above.
5. If you have any problems with this process –call our Helpline on
0800 008 6568