FireBoard FC11 User manual

Fire B oard®Case
Model FC11

Features
•Protection for your FireBoard thermometer during inclement weather and
outdoor activities
•Water resistant buttons and plugs provide full interaction with the device,
probes, accessories, and power
•Built-in kickstand for improved viewing angle
•Powerful magnetic base for mounting on most metallic surfaces
•Nylon strap can be attached to fit any mounting situation
What’s included
•(1) FireBoard Case with kickstand, magnets, and gaskets
•(2) Extra Probe Port Gaskets
•(1) Nylon Mounting Strap

Installing your FireBoard in the Case
Verify probe gasket is installed
The probe gasket should be seated evenly in the opening on the front of the base.
Place your FireBoard into base
The FireBoard will fit snugly and set just below the top of the case.
Hook the faceplate to the back of the case
Line up the 2 hooks on the underside of the
faceplate with the catches on the back of
the base. Using both hands, apply pressure
to the front and back of the case while
sliding the faceplate forward.
Snap the case together
Firmly press both sides of the faceplate down onto the
base - the front hooks will snap into place. The top is
now secured to the base and your FireBoard is ready
for use.
3
4
installation is a snap! install videos at fireboard.com/snap
2
1 2
3

Tips & Guidelines
When plugging in a probe use care to avoid damaging the gasket. The probe gasket has
small pre-cut slits over each port. Some wear-and-tear is expected with extended use -
we’ve included a replacement gasket that can be installed if necessary.
For easy removal of the FireBoard from the Case, simply open the
auxiliary port door and lift the edge of the device until it can be
removed completely.
The optimal placement for weather resistance is horizontal on a flat surface or with the
kickstand extended.
In wet conditions, the following may lead to increased chances of water entering the case:
•Mounting the FireBoard Case at an angle greater than 90° vertical
•Placing the FireBoard Case upside down
•Jets of water contacting the Case from below the faceplate or at extreme angles
around the gaskets
The FireBoard Case is not heat resistant - do not place on the surface of a hot smoker or
firebox.
The FireBoard Case is designed to be weather resistant; however, it is not waterproof.
Submerging the case in water or exposing it to extreme weather situations may lead to
damage of your FireBoard.

Faceplate
Screen gasket
Magnets Auxiliary Port Door
(hint: remove the
FireBoard by opening
this door and pushing the
FireBoard up)
Probe port gasket
Rubber feet
Kickstand
Kickstand grips
FireBoard not included

FireBoard Labs
Kansas City, MO
[email protected]
816-945-2232
www.fireboard.com
Download the official FireBoard®App:
FC11-UG-190513
* See fireboard.com/support
for device compatibility
Online Dashboard at fireboard.io
Monitor your temperatures, set alerts, view
session history all online.
Login to your account at fireboard.io
Installation Videos, How-Tos, Tutorials at
fireboard.com/snap
FireBoard is a trademark of FireBoard Labs, LLC
and is registered in the U.S. FireBoard®TM and
©2019 FireBoard Labs, LLC. All rights reserved.