Firstech 1WS2R-AF Technical manual

Patent: https://firstechllc.com/patents/
QUICK START CARD
Firstech, LLC. | 1
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
IC
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
This equipment complies with IC Nerve Stimulation Exposure limits set for an general public environment and meets
RSS-102 of the IC radio frequency (RF) Exposure rules.
Separation distance at least 3cm should be maintain from the device to user hand/foot during operation.
Separation distance at least 10cm should be maintain from the trunk of the body would rest in relation to the device
under test.

QUICK START CARD
QUICK START
1WS2R-AF
Firstech, LLC. | 2
Tap button 1 time to lock and/or arm your system.
Double tap button to unlock and/or disarm your system.
Hold button for 2.5 seconds to activate OR cancel the remote start sequence.
1 quick TAP THEN HOLD for 5 seconds to enable or disable proximity arming function.
BUTTON FUNCTION DESCRIPTION
To reprogram your remote, cycle the key in the ignition 5 times within 7 seconds. Parking lights will flash. Then tap the
Lock button on your remote. Repeat for any additional remotes. All remotes must be programmed during one sequence.
If you receive two parking light flashes, your Compustar has exited remote programming mode and you must retry.
Questions/comments? Contact us at 888-820-3690 from 8 AM to 5 PM PST. Also please visit
www.compustar.com for ser’s manual.
REMOTE FEATURES
Once the proximity lock feature is enabled, the system will search for the remote once the vehicle is off and all zones are
closed. Once the remote has left proximity of the antenna the system will arm/lock.
NOTE: If the remote is within range
of the antenna for 5 minutes the proximity lock feature will stop until a door is opened or vehicle is started.
15 seconds after the system is armed, the proximity antenna will begin to search for the remote. When the remote
moves within range of the proximity antenna (approx. 4-6 ft) the system will disarm/unlock automatically.
NOTE: The Orange LED on the remote will flash when the remote is within range of the proximity antenna
FEATURE
Proximity
Lock
Proximity
Unlock
FUNCTION/DESCRIPTION
NOTE: Passive arming feature 1-08 option 4 (proximity locking) must first be activated on the system by the install tech

QUICK START CARD
Firstech, LLC. | 3Firstech, LLC. | 3
QUICK START
The system is locked and ready to be armed.
The system is armed / passive arming is on.
The remote battery is low. Please replace the battery in the remote.
(Activated upon the initial "Doors unlock by 1WS2R-AF and Key On" sequence)
LEDs DESCRIPTION
Solid
Blinking
Solid (10sec)
ANT-1WAF

QUICK START CARD
ANT-1WAF
Firstech, LLC. | 4
<< Installation of Antenna Module >>
Note : The antenna module is mounted up in the vehicle’s dashboard.
Description of antenna module installation position
<< Harness >><< Antenna Module >>