Firstech FT-MB197-DC User manual

FT-MB197-DC Installation Guide
Data Controller (DC)
Remote Start for Mercedes
2011 SLS Class
Copyright 2013 Firstech, LLC. | 1
www.compustar.com
888.820.3690
Welcome to the installation guide for the 2011+ SLS Class Mercedes Benz. Please thoroughly review
this manual before installation as there are details that are essential to operation of the vehicle.
Please don’t forget to review the installation manual included with the DC unit.
This manual is intended for experienced installers. Firstech recommends professional installation as
we are not responsible for improper use and/or installation. For questions please call 888-820-3690
Monday through Friday 8 am to 5 pm PST.
Required Parts and Tools
T-20 Torx Driver• Right Angle Pick Tool•
Wire Ties• Panel Removal Tool•
Wire Loom• Drill•
10mm Socket and Ratchet• 3/4” Drill Bit•
Mercedes EIS removal tool (Part Number: 639 589 01 07 00)•
Optional in most installations however makes job much easier. It can
be purchased at your local Mercedes dealer.
DC Control Module
Black Plug
Supplied T-Harness
Valet Switch
After Installation
Before Installation
EIS Key
Cylinder
EIS Key
Cylinder
Wiring Overview
Blue Plug
Blue Plug
White Plug
Prewired KeylessGo Harness

FT-MB197-DC Installation Guide
Data Controller (DC)
Remote Start for Mercedes
2011 SLS Class
Copyright 2013 Firstech, LLC. | 2
www.compustar.com
888.820.3690
Instructions
1. Remove the cover from in front of the arm rest on the center console by pushing forward and lifting
up on the front first. This also will house the convertible top controls on equipped models.
2. Disconnect convertible switch if necessary and set the cover aside.
3. Remove (2) T-20 from under the cover and remove the plastic cover mount. (see pictures)
4. Remove (2) T-20 from the front section of the arm rest. (see pictures)
5. Remove (2) T-20 from inside the console cubby next to the key cylinder. (see pictures)
6. Remove (2) T-20 from inside the console at the bottom of the cup holders. (see pictures)
7. Using the EIS tool, remove the ring from the EIS.
8. Remove the armrest and upper cover to the console and set it aside. The EIS should separate from
the cover and stay connected and in the console area.
9. Disconnect the EIS plugs and connect the supplied T-harness in line between the factory wiring and
the rear of the EIS.
10. Locate the KeylessGo module behind the passenger seat by lifting up the carpet on the rear wall.
11. Unplug the connector containing the CAN wires and remove the black insert from the white
housing.
12. Insert the provided prewired KeylessGo plug into the housing and plug it back into the KeylessGo
module.
13. Turn on the valet switch and start the vehicle and let it run for 60 seconds. Verify there are no
error messages and that all functions are working properly.
14. Turn off the vehicle and press the panic button once to test the remote start.
15. Push the start button once on the console to perform a key take over. The lights should flash 3x
confirming the action.
16. If all is working as it should, the vehicle can be reassembled.
17. Locate a place to mount the valet switch. Drill a 3/4” hole and mount the switch.
18. Locate a place to mount the Mercedes DC control module away from heat and moving parts.
19. Reassemble the console and remount the EIS using the EIS tool and replace the (6) T-20 holding
the console in place.
20. Snap on the cover removed in step 1.
21. Tie up the KeylessGo wire harness neatly and replace the carpet panel behind the passenger
seat.

FT-MB197-DC Installation Guide
Data Controller (DC)
Remote Start for Mercedes
2011 SLS Class
Copyright 2013 Firstech, LLC. | 3
www.compustar.com
888.820.3690
Installation Images
Remove cover Lift front up first
Remove (2) T-20 screws Remove plastic mount

FT-MB197-DC Installation Guide
Data Controller (DC)
Remote Start for Mercedes
2011 SLS Class
Copyright 2013 Firstech, LLC. | 4
www.compustar.com
888.820.3690
Remove (4) T-20 Remove (2) T-20 and EIS ring
Console removed, EIS left T-harness installed between EIS and wiring

FT-MB197-DC Installation Guide
Data Controller (DC)
Remote Start for Mercedes
2011 SLS Class
Copyright 2013 Firstech, LLC. | 5
www.compustar.com
888.820.3690
KeylessGo plug removed CAN plugs switched
KeylessGo module properly interfaced
Firstech, LLC. is not responsible for any damages whatsoever, including but not limited to any consequential
damages, incidental damages, damages for loss of time, loss of earnings, commercial loss, loss of economic
opportunity and the like that may or may not have resulted from the installation or operation of the Data
Controller for Mercedes.
Installation Complete