Fishbone Offroad FB21230 User manual

FB21230
Toyota® Tacoma
Tackle Rack
2123000
REQUIRED TOOLS
Utility Knife
Rachet
19MM Socket
19MM Wrench
Thread Locker (Trim
dependent)
KIT CONTAINS
Foam Padding-Roll
Foam Padding-“L”
Foam Padding-Center Mounts
Arch Braces
Side Support Braces
Top Support Braces
Bed Channel Mount Brackets
M12 –1.75 x 30mm Carriage Bolt
M12 –1.75 x 50mm Carriage Bolt
M12 Washer 24mm OD
M12 –1.75 Hex Nut
M12 –1.75 x 60mm Hex Bolt
M12 –T Nut
M12 –1.75 x 25mm Hex Bolt
M12 –Lock Washer
QTY
1
4
2
3
2
2
6
18
12
38
34
4
10
10
34

FB21230
Toyota® Tacoma
Tackle Rack
1 2123000
1) PREPARE
Prior to installation, apply the adhesive foam
padding so that it covers any vehicle contact points,
arch and support brace connections, or where you
feel it’s needed.
2) INSTALL ARCH BRACES
Place the arches on the bed. The 2 arches with the
larger brackets belong on the outside.
The arch with our signature plate in the center faces
the rear. Spacing will be determined by the support
braces.
3) INSTALL TOP SUPPORT BRACES
Start installing the two thinner support braces. With
6 of the 30mm bolts, washers, and nuts, loosely
secure them to the top of the arches in your desired
locations.
4) INSTALL SIDE SUPPORT BRACES
Loosely install the larger braces onto the sides of
the arches, again using 6 bolt sets.

FB21230
Toyota® Tacoma
Tackle Rack
2 2123000
5) ADJUST SUPPORT BRACES
Slide the braces around to your liking and tighten
them down using a 19mm socket.
6) INSTALL BED CHANNEL MOUNT BRACKETS
Begin securing the rack to the bed by inserting two
50mm bolts into the included channel brackets as
shown. Rotate it behind the arch bracket and push
it high up against the plastic. With a 19mm socket,
tighten down a nut and washer while ensuring it
clamps onto the bed. Repeat for the remaining 5
brackets.
7) ACCESSORY MOUNTS
Using the 4 60mm bolts, washers, and nuts, secure
the hardware into the accessory mounts for future
use.
NOTE: If your vehicle comes with the Trail Rail, you
will need to insert the included (10) T-Nuts, lining
them up with each bracket.
Use the included Hex bolts, lock washers, flat
washers, and thread locker and secure the Bed
Rack down into the T-Nuts.
ENJOY YOUR NEW FISHBONE OFFROAD BED RACK!