Fishbone Offroad FB22004 User manual

FB22004
Jeep® JK Wrangler
Front Stubby Winch Bumper w/ Tube Guard
2200401
REQUIRED TOOLS
18mm Wrench
18mm Socket
16mm Wrench
16mm Socket
HARDWARE CONTENTS
D-Rings
M10 Hex Bolt
M10 Lock Washer
M10 Flat Washer
M10 Hex Nut
M12 Hex Bolt
M12 Lock Washer
M12 Flat Washer
M12 Hex Nut
QTY
2
8
8
16
8
6
6
12
6
* 14” LED light sold separately

FB22004
Jeep® JK Wrangler
Front Stubby Winch Bumper w/ Tube Guard
1 2200401
1) REMOVE YOUR FACTORY BUMPER
Begin by removing your factory bumper. Ensure you
disconnect your factory fog lights before you pull
your bumper away.
2) PREP YOUR NEW BUMPER FOR INSTALL
Before installing your bumper on your Jeep, we
suggest attaching your bumper tube, your optional
14” light bar, winch and fairlead (if applicable).
INSTALL YOUR BOLT-ON TUBE
Using one (1) M12 bolt, one (1) M12 lock washer,
two (2) M12 flat washers, and one (1) M12 nut per
hole, secure your tube to the top side of your
bumper. The front face of this tube will be secured
when the bumper is attached to your Jeep.
INSTALL THE FAIRLEAD BRACKET
If you wish to install a winch on your bumper, begin
assembly by attaching the fairlead bracket. Secure
the bracket to the bumper with one (1) M12 bolt,
one (1) M12 lock washer, two (2) M12 flat washers,
and one (1) M12 nut in both through holes.
INSTALL YOUR FAIRLEAD AND WINCH
We recommend installing the fairlead first as you’ll
have access to the bolts at this time. Follow the
instructions that came with your winch to install the
fairlead and winch body to the pre-drilled holes on
your new bumper.
INSTALL YOUR 14” LIGHT BAR
If you have purchased the optional 14” LED light bar
for your bumper, we recommend installing it after
your winch. The LED will make it difficult to get the
mounting hardware for the winch installed.
Using the supplied hardware that came in the LED
kit, secure it to the bumper between the inner
brackets.

FB22004
Jeep® JK Wrangler
Front Stubby Winch Bumper w/ Tube Guard
2 2200401
3) INSTALL YOUR BUMPER
2 PERSON LIFT
WITH THE WEIGHT OF THE WINCH AND BUMPER, IT
IS HIGHLY ADVISED TO HAVE HELP WHEN
INSTALLING THE BUMPER!
With the help from a second pair of hands, lift the
bumper up to the frame of the Jeep. Using the M10
hardware, insert an M10 bolt and washer through
the front of the bumper and into the bumper bracket
on the frame of your Jeep. Secure each bolt with an
M10 flat washer, M10 lock washer, and M10 nut.
4) MOUNT THE SUPPLIED D-RINGS.
5) RUN YOUR WIRING
Wire your new LED light using the supplied wiring.
DO NOT WIRE THIS DIRECTLY TO YOUR OEM FOG
LIGHT HARNESS.
Wire your winch according to the winch
manufacturer’s instructions.
6) ENJOY YOUR NEW FISHBONE OFFROAD BUMPER!