FB33007
Jeep® JK Wrangler
Aluminum Inner Fenders
1 3300700
FRONT INNER FENDERS:
1) REMOVE YOUR FRONT OEM INNER FENDER/LINER
Use a 10mm socket and flat head screwdriver to
remove the bolts and clips from the inner fender
liner. Remove the fender liner.
2) INSTALL YOUR FRONT INNER FENDER SUPPORT
ARMS
Passenger side – install the nutsert tab on the back
side of the inner fender and facing the rear of the
Jeep. Do not tighten at this time
Driver side – install the nutsert tab on the back side
of the inner fender and facing the front of the Jeep.
Do not tighten at this time.
3) INSTALL YOUR FRONT INNER FENDERS
Place the inner fenders inside the fender well. Using
the supplied hardware, secure the inner fender to
the Jeep using the OEM fastener locations. Install all
screws loosely to allow adjustments. It may take a
little pressure to get these to line up with the OE
holes.
On the forward most holes, you will need to drill a
¼” hole using the inner fender as your template.
Install screw and washer and tighten the nut.
Working from the front of the vehicle to the rear,
tighten all bolts with a 3mm Allen wrench. When
the rearmost screw is tightened, it will turn the
nutsert tab against your Jeep and lock it into place.
REAR INNER FENDERS:
1) REMOVE YOUR REAR OEM INNER FENDER/LINER
If necessary, jack up your vehicle to give you more
room to work. Ensure the vehicle is safely
supported. Release the inner fender/liner by
removing the push rivets from the Jeep fender well.
2) INSTALL YOUR REAR INNER FENDERS
The below image shows which side to install the
rear inner fenders on.
Flex and manipulate your new inner fender to work
it into the fender well and around your tire. Work
the inner fender until you have snapped it into
place around all the Jeep fender edges and frame.
Pre-drill five (5) holes using a 5/32” drill bit. USE
CAUTION WHEN DRILLING TO NOT HIT FUEL LINES
OR HARNESSES. Using the supplied screws, secure
the rear inner fenders in place.
TIP! – Hold the inner fender in the highest possible
point before drilling holes.
3) ENJOY YOUR FISHBONE OFFROAD INNER FENDERS!
