Fisher & Paykel OR90SDBGFX2 User manual

Using your gas cooktop
Before using your new cooktop, please read this user guide, taking special note of the ‘Safety and warnings’ section,
make sure all burner control dials are turned off, and turn the power to the cooker on at the wall.
Fig 27 Cooktop layout
1. Triple-ring wok burner
2. Semi-rapid burner
3. Dual burner
Gas burners
The dial controls the flow of gas through the safety valve.
Semi-rapid and triple-ring wok burners
▪ = closed valve (OFF)
▪ = maximum flow of semi-rapid and triple-ring burner burners
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
1

▪ = minimum flow of semi-rapid and triple-ring burner burners
You can choose to cook at any heat between
and
, but never between
and
(OFF).
Dual burner
▪ = closed valve (OFF)
▪ = maximum flow of inner crown only (turn dial clockwise)
▪ = minimum flow of inner crown only (turn dial clockwise)
▪ = maximum flow of inner & outer crowns (turn dial anticlockwise)
▪ = minimum flow of inner & crowns (turn dial anticlockwise)
You can choose to cook at any heat between
and
or between
Fig. 28 Burner control dial
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
2

and
, but never between
and
(OFF) or between
and
(OFF).
Before using your cooktop
Before using your new cooktop, please:
▪ Read this user guide, taking special note of the ‘Safety and warnings’ section.
▪ Make sure all burner control dials are turned off.
▪ Turn the power to the cooker on at the wall.
Using the gas burners
1. Choose the control dial for the burner you want to use.
2. Semi-rapid and triple-ring burners: press the dial in gently and turn it anticlockwise to the
position. The ignitors on all the burners will spark.
Dual burner: press the dial in gently and turn it anticlockwise to the
position (to ignite the inner and outer crowns) or press the dial it gently and turn it clockwise to the
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
3

position (to ignite the inner crown only). The ignitors on all the burners will spark.
Hold in the dial for approximately 10 seconds after the burner has lit. Releasing the dial too soon will extinguish
the flame.
3. Adjust the flame anywhere between
and
or
and
or
and
positions. Do not adjust the flame between
or
or
and
(OFF).
If the burner does not light within 15 seconds, turn the control dial off and wait at least one
minute before trying again.
4. To turn the burner off, turn the dial clockwise (semi-rapid and triple-ring burners or dual burner when using both
crowns) or anticlockwise (dual burner when using the inner crown only) to
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
4

(OFF) until you hear the safety click.
5. After use, always turn the dials to the
(OFF) position.
Flame failure safety feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold down the dial for approximately 10 seconds after the burner has lit. Releasing the
dial too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one
minute (to allow the gas to disperse).
If a burner does not light
Check that:
▪ The cooker is plugged in and the electricity is switched on.
▪ The gas is turned on.
▪ The gas bottle is not empty (if you are using bottled gas).
▪ You have held down the dial for at least 10 seconds.
▪ The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them with a toothbrush
and methylated spirits, as shown in Fig.31.
Fig. 29 Cleaning the probe and ignitor
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
5

If the flame is irregular
If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
▪ clean and dry.
▪ positioned correctly. See ‘Care and cleaning’.
▪ See also ‘Cooktop troubleshooting’.
Matching cookware to burner
Use flat-bottomed pans, and make sure they match the size of the burner, as shown in the following table. A
small pot on a large burner is not efficient.
Diameters of pans which may be used on the cooktop
Burners Minimum Maximum
Semi-rapid 10 cm 24 cm
Triple-ring wok
26 cm 28 cm
Maximum diameter for woks 36 cm
Dual (inner crown only) 12 cm 14 cm
Dual (inner and outer crowns)
26 cm 28 cm
Maximum diameter for woks 36 cm
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
6

Fig. 30 Correct and incorrect matching of cookware
and burner size
Fig. 31 Efficient and inefficient saucepan bottoms
Wok stand
The wok stand fits over the dual the triple ring burner pan support.
• Using a wok without the stand may cause the wok to tip or the wok, triple ring or dual burner to
operate incorrectly.
• Do not use the stand for ordinary, flat-bottomed saucepans.
• The wok stand MUST BE PLACED O LY over the pan support for the triple ring or dual burner.
The cooktop becomes very hot during operation. Keep children well out of reach.
Fig. 33 Correct placement of wok stand
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX2/User_Guide_OR90SDBGFX…
Updated: Mon, 10 Apr 2023 23:53:48 GMT
Powered by
7