Fisher & Paykel DW60FC4W1 User manual

Fault codes
If the dishwasher malfunctions, it will display a fault code and beep. Check the table below to see if you can correct the
fault yourself before contacting Fisher & Paykel Customer Care.
If the dishwasher still will not work, or shows any other fault code
1. Press
to turn the dishwasher off and wait a few minutes.
2. Press
again to turn the dishwasher back on.
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher from the power
supply, turn the water supply off, then contact Fisher & Paykel Customer Care with the fault code information.
Fault codes
and
Descriptions
Possible Causes What to do
Drain fault
Drain hose is crimped or bent. Check the drain hose and straighten if needed.
The waste water is not draining
out.
Ensure that the drain hose is connected in accordance with
the installation instructions.
The turbidity sensor is dirty and
requires cleaning.
Gently clean the turbidity sensor with a soft brush (ie
toothbrush) to remove any buildup.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60FC4W1/User_Guide_DW60FC4W1/15_Fault_codes
Updated: Sat, 15 Feb 2020 09:20:35 GMT
Powered by
1

Fault codes
and
Descriptions
Possible Causes What to do
No water
Water tap not turned on.
Ensure the water is connected and turned on. Press
to restart the dishwasher.
Insufficient water supply pressure. Check household water pressure.
Water inlet hose is crimped or bent,
so no or not enough water gets to
the dishwasher.
Check the water inlet hose and
straighten if needed. Press
to restart the dishwasher.
Drain hose is not connected
correctly.
Ensure that the drain hose is connected in accordance with
the installation instructions.
Flooding
Flood switch activated.
Turn the dishwasher OFF and ON again. If fault persists, turn
water off and disconnect the dishwasher from the power
supply. Call Customer Care.
Water flow error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60FC4W1/User_Guide_DW60FC4W1/15_Fault_codes
Updated: Sat, 15 Feb 2020 09:20:35 GMT
Powered by
2

Fault codes
and
Descriptions
Possible Causes What to do
Electronics error. Switch dishwasher OFF and ON again. If the fault persists
call Customer Care.
Water temperature error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
(DW60FC6
only)
Data/electronics error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
Electronics/power supply error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
(DW60FC6
only)
Doorlock signal error. Switch dishwasher OFF and ON again. If fault persists call
Customer Care.
(DW60FC6
only)
Motor fault.
Switch dishwasher OFF at the power supply. Wait a few
moments and switch ON again.
If the fault persists, turn water off and disconnect from the
power supply. Call Customer Care.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60FC4W1/User_Guide_DW60FC4W1/15_Fault_codes
Updated: Sat, 15 Feb 2020 09:20:35 GMT
Powered by
3