Fisher & Paykel HC60DCXB1 User manual

Installation instructions
Please read and follow the ‘Safety and warnings’ and ‘installation instructions’ sections carefully before using your
rangehood.
Contents of packaging
Rangehood (1)
Installation instructions User guide manual (1)
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
1

Upper chimney (1) Upper chimney bracket (1)
Ducting adapter (150 mm Ø)
(1) Expansion plug (8) 30 mm self tapping screw (8)
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
2

10 mm self tapping screw (4)
Product dimensions
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
3

https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
4

Property (mm) HC60 HC90 HC120
A. Overall height of product 595 – 1035 595 – 1035 595 – 1035
B. Overall width of product 598 898 1198
C. Overall depth of product 500 500 500
D. Height of hood 55 55 55
E. Height of stainless strip 27 27 27
F. Width of chimney 320 320 320
G. Depth of chimney 290 290 290
H. Distance from centre of ducting outlet to back of product 105 105 105
I. Distance from centre of ducting outlet to side of chimney 160 160 160
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
5

Property (mm) HC60 HC90 HC120
J. Diameter of ducting outlet 150 150 150
K. Distance between centre of lights 230 230 230
L. Distance from centre of lights to back of product 45 45 45
Length of power cord 1500 1500 1500
Actual product dimensions may vary by ± 2 mm.
Please read the entire instructions before installing the rangehood.
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
6

Height of rangehood
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
7

Installation Dimensions
Property (mm)
M. Installation height
Ducted
Recirculation
min. 635 – max. 1035
min. 675 – max. 1035
N. Height top of cooktop to base of product
Electric cooktop
Gas cooktop
min. 600 – max. 750
min. 650 – max. 750
Rangehood installation height above the cooktop is the user’s preference. Lower installation heights will improve
the efficiency of capturing cooking odours, grease, and smoke. This rangehood must be installed between the
minimum and maximum dimensions indicated in the table above.
Venting options
Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are
fulfilled.
The rangehood can be installed to operate with the exhaust air ducted externally from the kitchen, or installed to
operate with the exhaust air recirculating within the kitchen.
Ducted
For ducted installation it is recommended that 125 mm diameter, rigid or semi-rigid ducting is used. This will
require a 135 mm (min) round hole in the ceiling or wall. Care should be taken to position the hole correctly.
For optimal efficiency use the shortest and straightest duct route possible and use rigid or semi-rigid ducting for
reduced noise and increased airflow. Flexible metal ducting should only be used as a last resort (ie in difficult
installations) and if used ensure that it is straight and smooth and extended as much as possible.
Recirculating
To enable the product to operate with the air recirculating, please purchase a recirculation diverter and carbon
filters (refer to the ‘Parts and accessories’ section). The recirculation diverter is installed after a short length of
ducting and is required to channel the air out the side vents at the top of the chimney and the carbon filters are
required to remove odours.
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
8

A ducting hole is not required in the wall or ceiling if the rangehood is installed to operate
with exhaust air recirculating.
• This appliance is heavy and requires two persons for unpacking and installation
• Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards.
• Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1. Prepare for installation.
Before installing your rangehood:
• Please read the instructions carefully.
• Unpack the rangehood and check that all functions are working.
• Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and frequency
at the installation site.
• Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc.
• The stainless steel and glass surfaces of the rangehood are very easily damaged during installation if grazed or
knocked by tools. Please take care to protect the surfaces during installation.
• Protect the cooktop surface below with cardboard, or the like, to prevent damage occurring whilst the rangehood
is being installed above.
• Temporarily mark the height of the bottom of the rangehood and the centre of the cooktop on the wall according
to the information given in the ‘Installation instructions – Height of rangehood’ section.
• The wall used for mounting the rangehood should have sufficient strength and a flat surface.
2. Attach chimney brackets and hood mounting screws
• Attach the chimney bracket and upper chimney bracket (if using the upper chimney) in the locations shown in
Fig.2 and 3. Use the 30 mm screws and expansion plugs if attaching to masonry.
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
9

• Attach the upper hood mounting screws in the locations shown in Fig.2 and 3. Use the 30 mm screws and
expansion plugs if attaching to masonry. Ensure that there is a 2 mm gap between the screw head and the wall
– see Fig.1.
Fig.1
Fig.2
Product Dimensions
Property (mm) HC60 HC90 HC120
A. Lower rangehood attachment point width 420 580 900
https://producthelp.fisherpaykel.com/nz/Cook/Rangehoods/Canopy/HC60DCXB1/User_Guide_HC60DCXB1/03_Installation_i…
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
10