Fisher-Price W9453 User manual

www.fisher-price.co.uk
W9453
• IMPORTANT! KEEP FOR FUTURE REFERENCE.
• Please read these instructions before
assembly and use of this product.
• Adult assembly is required. Tool needed for
assembly: Phillips Screwdriver (not included).
• Requires one "D" (LR20) alkaline battery (not
included) for soothing unit operation.
• Product features and decorations may vary
from photographs.

2
To prevent serious injury or death:
• Fall Hazard-Neveruseonany
elevatedsurface,sincechild's
movementmaycausetheproductto
slideortipover.Useonlyonaoor.
• Suffocation Hazard -Neveruseon
asoftsurface(bed,sofa,cushion)
sincetheproductcantipoverand
causesuffocationinsoftsurfaces.
•Alwaysuserestraintsystem.
•Neverleavechildunattended.
•Donotuseproductoncechildcan
situnaided.
•Thisproductisnotintendedtoreplace
acotorbedforprolongedperiods
ofsleep.
•Neverusetoybartocarryproduct.
•Neveruseasacarrierorliftwhile
childisseated.
WARNING
Consumer Information
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel for
replacement parts and instructions if needed. Never substitute parts.
• Use from birth until child is able to sit up unassisted.
• Weight limit: 9 kg (20 lbs)
• This product does not replace a cot or bed. Should the child need
to sleep, place the child in a suitable cot or bed.
Parts
Pad
Soothing Unit
Frame
IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.
Note: Screw shown actual size. Tighten or loosen all screws
with a Phillips screwdriver. Do not over-tighten the screws.
M5 x 20 mm Screw – 2
Great Britain: Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303. www.service.mattel.com/uk.
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331,
Auckland.
Asia: Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Malaysia: Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.
(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran
Tropicana Golf Country Resort, 47410 PJ. Tel: [phone].
©2011 Mattel. All Rights Reserved.
PRINTED IN CHINA W9453a-0726

3
• Place the frame on a flat surface.
• Press the button on the frame hub.
1
2
• Pull the front legs apart until you hear a "click".
Hub
PRESS
Front Legs
Assembly
4
• Insert the screws into the back legs and tighten.
Screws
3
• Fit the ends of the back legs into the posts on the hub.
Hint: The legs are designed to fit into the hub one way. If they do
not seem to fit, try the other leg.
Back Legs
Posts
• Position the soothing unit so that the flat side is up.
• Fit the soothing unit into the pocket in the seat liner.
5
Soothing Unit

4
Assembly
• Position the pad above the frame.
• Fit the waist belts and crotch pad up through the slots in the pad.
Make sure the belts and pad are not twisted.
6
Waist Belts
Crotch Pad
7
• Fit all four retainers through the button holes on each side of
the pad.
• Wrap the pad strap around the top of the seat liner and press to
fasten in place.
Retainers
Retainers
Strap
9
• Rotate the canopy over the seat.
• Open the fasteners on both pockets in the canopy.
• Pull to remove the hanging toys from the pocket.
Canopy
8
• Fasten the pad buckles on the front edge of the pad and underneath
the seat. Make sure you hear a “click” on both sides.
Toys
Canopy Pockets

5
Battery Installation
Hint: We recommend using an alkaline battery for longer battery life.
• Pull to remove the soothing unit from the pocket on the front of
the seat.
1
• Loosen the screws in the battery compartment door. Remove the
battery compartment door.
• Insert one “D” (LR20) alkaline battery into the battery compartment.
• Replace the battery compartment door and tighten the screws.
• Position the soothing unit so that the flat side is upright.
• Fit the soothing unit in the pocket on the front of the seat.
• If this product begins to operate erratically, you may need to reset
the electronics. Slide the power switch off and then back on.
2
+
–1,5V
“D” (LR20)
Soothing Unit
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Battery Safety Information

6
To prevent serious injury or death:
• Fall Hazard-Neveruseonany
elevatedsurface,sincechild's
movementmaycausetheproductto
slideortipover.Useonlyonaoor.
• Suffocation Hazard -Neveruseon
asoftsurface(bed,sofa,cushion)
sincetheproductcantipoverand
causesuffocationinsoftsurfaces.
•Alwaysuserestraintsystem.
•Neverleavechildunattended.
•Donotuseproductoncechildcan
situnaided.
•Thisproductisnotintendedtoreplace
acotorbedforprolongedperiods
ofsleep.
•Neverusetoybartocarryproduct.
•Neveruseasacarrierorliftwhile
childisseated.
WARNING
• Press the button on the frame hub.
1
• Pull the front legs apart until you hear a "click".
2
PRESS
Hub
Front Legs
Setup and Use
Restraint Belts
Securing Your Infant
• Place your child in the seat. Position the crotch pad between your
child’s legs.
• Fasten the restraint belts to the crotch pad. Make sure you hear
a “click” on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
• Tighten each waist belt so that the restraint system is snug against
your child. Please refer to the next section for instructions to
tighten the waist belts.
Crotch Pad
3
To tighten the restraint belts:
• Feed the anchored end of the restraint belt up through the buckle
to form a loop A. Pull the free end of the restraint belt B.
To loosen the restraint belts:
• Feed the free end of the restraint belt up through the buckle to
form a loop A. Enlarge the loop by pulling on the end of the loop
toward the buckle. Pull the anchored end of the restraint belt to
shorten the free end of the restraint belt B.
TIGHTEN LOOSEN
4
Free End
Anchored End Anchored End
Free End

7
Setup and Use
Power Switch
Soothing Unit
• Make sure your child is properly secured in the seat.
• Slide the power/mode switch to music, vibrations or
music and vibrations.
• The soothing unit will stay on for approximately 20 minutes.
Slide the power/mode switch OFF and then back on to restart.
IMPORTANT! Low battery power causes this product to operate
erratically: no sounds or vibrations and the product may not turn
off. Remove and discard the battery and replace with a new
“D” (LR20) alkaline battery.
• When you are finished using this product, slide the power/mode
switch OFF .
5
To remove the pad:
• Unfasten the buckles.
• Pull the restraints through the slots in the pad.
• Pull to remove the pad from around the retainers and the
soothing unit.
• Lift to remove the pad.
• To replace the pad, please refer to the Assembly instructions.
• The pad is machine washable. Wash it separately in cold water on
the gentle cycle. Do not use bleach. Tumble dry separately on low
heat and remove promptly.
Care
• The frame (including liner, canopy and toys) may be wiped clean
using a mild cleaning solution and damp cloth. Do not immerse.
Do not use bleach. Do not use harsh or abrasive cleaners. Rinse
clean with water to remove residue.
• Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities.

8
Storage
• Fit the toys inside the storage pocket on the front of the canopy.
• Rotate the canopy behind the seat.
• Press the button on the hub.
• Push the legs together until you hear a "click".
• To setup again: First press the button on the hub and then pull
apart the front legs. Make sure you hear a "click".
1
2
3
4
PRESS
Hub