FJK home products ET-3118-CG-T User manual

40" Square Steel Slat Table
MODEL#:ET-3118-CG-T
User Guide
P4

A B C
D E
Ax1 Bx4 Cx1
Dx4(M6X20)
Ex8(M6x35)
F
Fx12
READ AND SAVE THESE INSTRUCTION
Please read instruction carefully and identify all the parts before assembly.
※ Caution : Small parts like plastic caps and bolts, may pose a choking hazard to young children.
Keep out of reach of small children.
Parts
G
Gx8
HI
Hx8 Ix1
J
Jx1
Table Top Leg Fixed Frame
Bolt Bolt Washer
Nut Bolt Cap Hex Wrench
Driver
STEP 1: Place Table Top (A), upside down, on a non-abrasive, flat surface.
Note: There are four (4) leg receivers, one in each corner of the table. Insert
each of the four (4) Legs (B) into the leg receivers. Attach legs to table top using
Bolts (D), Washers (F) and Bolt Caps (H) as shown in the drawing.
STEP 2: Attach the Fixed Frame (C ) to
the four Legs (B) with Bolts (E), Washers
(F), Nuts (G) and Bolt Caps (H) as shown
in the drawing. CAUTION: Do not
tighten the Bolts (E) until the assembly of
the table is complete.
STEP 3: Once all Legs (B) have been
properly attached to the Table Top (A),
tighten the Bolts (E), Nuts (G) and cover
with Bolt Caps (H). When assembly is
complete, turn the table right side up.
You may now enjoy your new table!
P2 P3