FJK home products GS-5036 User manual

CUSTOMER SERVICE
M-F 9:00AM-4:00PM CDT
Phone:[phone]
Email:[email protected]
Website:fjkhomeproducts.com
MADE IN TAIWAN
AFTER SALES SUPPORT P6 AFTER SALES SUPPORT P1
PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com
BEFORE ASSEMBLY
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS

PLEASE READ PRIOR TO ASSEMBLY
This product use special connection system,Com-Lock and Cam-bolt.
Thank you for purchasing this quality FJK product. Please be sure to carefully check that all Please make suer to assemble cam-lock and com-bolt an following figure.
small parts are present as they can come loose during the shipping process. If you find that
there are initially missing or damaged parts, contact our Customer Service Department,
via phone or email as shown at the bottom of each page of Assembly Instructions.
IMPORTANT: FOLLOW THE ASSEMBLY INSTRUCTIONS IN NUMBERED
SEQUENCE IN ORDER TO PREVENT DAMAGE TO PARTS. THIS WILL
ASSURE FAST, EASY AND PROPER ASSEMBLY.
WARNING: WHEN INSTALLING SCREWS, DO NOT TURN TOO TIGHTLY
AS THIS MAY RESULT IN DAMAGE TO PRODUCT.
GLUE AND WOOD DOWEL INSTALLATION
AFTER SALES SUPPORT P2 AFTER SALES SUPPORT P3
PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com
13
1 2
3 4

AFTER SALES SUPPORT P4 AFTER SALES SUPPORT P5
PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com PHONE:[phone] EMAIL:[email protected] WEBSITE:fjkhomeproducts.com
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
3
3
2
1
C
D
(B,L)
( B,R )
3
4
A
3
6
STEP 1
Fit part (C), bottom wooden brace, into parts (B) legs, on both right and left hand sides.Insert
part (3) screws into each side of legs and through bottom wooden brace.Turn screws until
they are tightly in place. Do not over tighten screws as it may cause damage.Place flat
wooden brace, part (D), between legs where indicated on diagram and secure with part (1)
cam bolts,
on sides and part (2),Tighten the
cam bolts and cam locks until they
lock tightly into place. Cover cam
locks with part (6) plastic cap to
prevent scratches.cam locks in
front as shown. Insert cam bolts on
sides of flat wooden brace and
cam locks in front of wooden brace
as shown. Tighten the cam bolts
and cam locks until they lock tightly
into place. Cover cam locks with
part (6) plastic cap to prevent
scratches.
Attach Jewelry Wardrobe, part (A) to legs, as shown in diagram, using part (3)
screws. Tighten screws until secure. Do not overtighten screws as it may cause
damage.Insert part
(4) regulators into holes
where shown to hold
wardrobe steady. Assembly
is complete. 