Flash STROBO FL-1500SC DMX User manual

STROB
O
FL-
1500
O
FL-1500SC
DMX
User Manual
1500
SC DMX
DMX

FL-1500SC DMX
www.flash-butrym.pl 2
Contentes
•Security description
•Point for attention
•Controller functions
•Technique specifications
•Illustration diagram for product structure
Security description
Before using the strobe light, you must open the cover, remove the
black EPE, to prevent the high voltage burning the EPE.
1. Please read all instructions in detail.
2. Please keep this manual well.
3. Please follow all cautions or warnings and instructions for this
product.
4. Do not connect this product to power supply when clean the
lighting equipment.
5. Do not put the lighting equipment near the water sources.
6. The slots and opens on the bottom of the cover are used for
ventilation of the machine body to ensure the lighting equipment
to work in effectiveness and prevent overheat of the machine
these slots and opens must be cleaned at regular intervals.
7. Do not insert the irrelevant articles through slots and opens into
the machine body to avoid that the articles will touch the high
voltage components and lead to short circuit in the components
and lead to short circuit in the components and fire or electronic
attack maybe happened.
8. Do not repair or maintain this equipment yourself because of the
high voltage or other dangers after opening the cover the
qualified maintenance technician shall be checked. For whole
and full maintenance.

FL-1500SC DMX
www.flash-butrym.pl 3
Function and Operation
DMX512 connecting:
Controller contain DMX512 signal output standard use input output (3
pin XLR connector) to connect controller and light. Make sure the
control cable output pins were corresponding to the XLR connector of
the light, 1 for GND 2 for- 3 for +. Otherwise, exchange 2pin and
3pin. Connect cable length less then 100m, or will be interfered by
other machines.
1. Address code setting:
The light should controlled by DMX512 signal All lights of this kind
needs a data start address code for the purpose of the one signal
controls the corresponding light. The data start address code also
names section number. Light operate by controller sending out the
data. The light use 3 channel sections.
Channel 1: Dimmer
Channel 2: Flash Speed
Channel 3: Value 0-128 Auto mode
Value 129-255 Sound mode
Function Setup
FUNCTION ADDRESS ON ADDRESS OFF
Auto Mode 9, 10 1,2,3,4,5,6,7,8
Sound Mode 10 1,2,3,4,5,6,7,8,9
DMX512 Control 1 2,3,4,5,6,7,8,9,10
Slave LIGHT No 1,2,3,4,5,6,7,8,9,10
Specifications
1. Voltage: AC 220V +/- 10%; 50-60Hz
2. Power: 1500W
3. Fuse: 20A
4. DMX512 channel: 3ch
5. Net. Weight: 4kg
6. Gross Weight: 5kg
7. Size: 540x300x205mm