Flex-a-Lite 125 User manual

The Flex-a-lite Limited Warranty
Flex-a-lite Consolidated, 7213-45th St. Ct. E., Fife, WA 98424, Telephone No. 253-922-2700, warrants to the original purchasing user, that all Flex-a-lite products to be free of defects in material and
workmanship for a period of 365 days (1 year) from date of purchase. Flex-a-lite products failing within 365 days (1 year) from date of purchase may be returned to the factory through the point of
purchase, transportation charges prepaid. If, on inspection, cause of failure is determined to be defective material or workmanship and not by misuse, accidental or improper installation, Flex-a-lite
will replace the product free of charge, transportation prepaid. Flex-a-lite will not be liable for incidental, progressive or consequential damages. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary
from state to state. The Flex-a-lite warranty is in compliance with the Magnuson-Moss Warranty Act of 1975.
Honda Civic 1992-2000
FAL Part 125
Installation Instructions
rev. 05-09-07 part no. 99077 Page 1
1. Disconnect battery by removing negative terminal.
2. Find the gray electrical connector on the fan, usually mounted on passenger side of old shroud
Un-plug it. (you need to push in on a tab on the male half to release a catch hidden inside the
connector)
3. Unscrew the old fan at the top (2 screws), at the bottom (2 screws). Keep the screws. On some
Civics, there are no screws at the bottom. Take out the old fan.
4. Attach the top & bottom brackets to your new, improved FAL fan with the serrated phillips screws
supplied.
5. Slide the fan into place, and reattach with the original screws. Use washers provided for radiators
that require screws at the bottom.
6. Reconnect the electrical connectors back together, and apply warning decal to a highly visible
spot in engine compartment.
7. Reconnect battery
8. Drive away - You are finished!
Note: If you work on the engine with the ignition on,
the fan may come on unexpectedly when the engine is warm.