Flexitron webdyn MTX-StarWater User manual

MTX-StarWater
Power-Up Guide
www.webdyn.com

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
2
Index
Power-Up Guide................................................................................................................ 3
1. Plug In the Water Meter........................................................................................................................ 3
2. Insert the microSIM Card in the Folding Tray...................................................................................... 4
3. Plug In the Battery Connector.............................................................................................................. 5
4. Start the Operation............................................................................................................................... 6
5. Connect the Interface Cable ................................................................................................................ 6
Sales Contact ................................................................................................................... 7

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
3
Power-Up Guide
Following this guide you will learn how to connect your Starwater device to a pulse water meter.
1. Plug In the Water Meter
• Loosen the cable gland and introduce the cable.
• It is highly recommended to use cable end caps for a proper connection.

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
4
• Connect the meter cables following the next pinout:
GNDPulse Tamper
• Tighten the cable gland to prevent moisture from entering.
2. Insert the microSIM Card in the Folding Tray
• To unlock the tray, slide it towards push button near.
• Close and lock the tray sliding it.

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
5
3. Plug In the Battery Connector
4. Start the Operation

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
6
• Push the reading button to initialize the system for the rst time after connecting the battery.
• This button forces an immediate reading of the internal register pulse counter and a connection
to the cloud platform to upload data and check for pending commands. You can also use this
function approaching a magnet from outside of the enclosure near to the same place. To avoid
wasting battery, there is a maximum of 10 times a day for this functionality.
5. Connect the Interface Cable
• This cable is used to apply some local congurations if required. For that, please contact our
support team to get the latest version of the StarwaterApp Desktop Tool.

[e-mail] | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
7
Sales Contact
SPAIN
C/ Alejandro Sánchez 109
28019 Madrid
Phone 1: 902.19.81.46
Phone 2: +34-91.560.27.37
Email: [email protected]
FRANCE
26 Rue des Gaudines
78100 Saint-Germain-en-Laye
Phone: [phone]
Email: [email protected]
INDIA
803-804 8th oor, Vishwadeep Building
District Centre, Janakpurt, 110058 New Delhi
Phone: [phone]
Email: [e-mail]
PORTUGAL
LusoMatrix Lda.
Av. Coronel Eduardo Galhardo 7-1ºC
1170-105 Lisbon, Portugal
Phone: [phone]
Email: [email protected]
A PA C
9F, No. 156, Sec. 3, Minsheng E. Rd.
Songshan Dist., Taipei City 10596, Taiwan
Phone: [phone]
Email: [email protected]
AUE
Dubai
Phone: [phone]
Email: [email protected]
USA
Chicago
Phone: [phone]
Email: [email protected]