Flower House BloomHouse Manual

Self-erecting portable greenhouses Set up Instructions
Step 1: Remove
your BloomHouse™
from the pack. Place
the hub ends on the
ground.
Step 2: Open the
Bloomhouse™ from the top and
lay it on the ground. It will open
up into a star shape. NOTE: It
will not lay flat.
Step 3: Reach to the center of
the BloomHouse™ and grab the
strap attached to the hub. Pull
firmly on the strap.
Step 4: The top will pop up.
Step 5: Then lift the top of the BloomHouse™ so you can reach
the hub strap of one of the walls. Grab the strap and pull firmly
until the wall pops out. As shown in "E & F"
Step 6: Repeat STEP 4 with 3 remaining
sides. Pull firmly on each hub strap until all of
the walls are popped out. Shown in "G & H".
Page 1

Self-erecting portable greenhouses
Page 2
Step 7: Secure your BloomHouse™ using the
supplied stakes. Insert the stakes into the stake holes
of the skirt at 45°angle. Keep as much tension on the
rope as possible. Repeat this step with all hub
locations. For added safety, attach the remaining 4
high-wind tie-downs to the top 4 corners of the
BloomHouse™ and secure them with stakes.
Step 8: The doorway and vents of the
BloomHouse™ can be secured open for
ventilation. To secure them, first unzip them.
Roll them up and use the straps to hold them
in place. Shown in "11& 12".
Parts List:
BloomHouse™ (84" x 84" x 84")
Ground Stakes
High-Wind Tie-Downs
Shade Cover
Set up Instructions

Self-erecting portable greenhouses Take Down Instructions
Step 1: To take down your
BloomHouse™ begin by removing all
high-wind tie-downs and stakes. It
may be easier for you to use the head
of one stake to remove
another. Shown in A.
Step 2: With an open palm, push on the hub of one of the
walls. It will collapse. Continue around the BloomHouse™,
pushing on the hubs of the walls, until all 4 walls have
collapsed.
Step 3: Reach to the center of the BloomHouse™ and push
in the hub so the roof will collapse. REMEMBER: It will not
lat flat. Shown in "D & E".
Step 4: Gather the corners of
the BloomHouse™
Step 5: Use the provided
material to tie around it to hold
it place.
Step 6: Place the BloomHouse™ in its pack with the hubs
down. Store the stakes and high-wind tie-downs in the
pouches provided and place them in the pack. Now you can
take your BloomHouse™ anywhere!
Page 1