Flower House PlantHouse 2 Manual

Self-erecting portable greenhouses Set up Instructions
Page 1
Step 1: Remove your
PlantHouse 2'™ from the
pack.
Step 2: Allow your
PlantHouse 2' ™ to spring
open. CAUTION: Be
Sure to hold your
PlantHouse™ away from
your face as it will
Spring open.
Step 3: Unfold
your PlantHouse
2'™ into 2 panels.
Step 4: Grab the
center steel band and
lift up to separate the
two sides of your
PlantHouse™.
Smooth and unfold
the skirting.
Step 5: Assemble
the fiber pole
provided. Insert the
capped ends into the
pockets above the
doorway and
opposite end.
Step 6: The doorway
and screen can be
secured open either
together or
separate. Simply
unzip the doorway
and/or screen. Roll
them long way.
Secure with the
straps provided.
Attach your shade
cover for added
protection.

Self-erecting portable greenhouses Take Down Instructions
Page 1
Step 1: Begin first by
removing all of the stakes.
It may be easier for you to
use one stake to remove
another.
Step 2: Be sure your doors and screens are zipped
closed, then place your PlantHouse™ on it's side and
remove the fiber pole from the ceiling.
Step 3: Push on the center
steel band. The two top bands
must be forced to lay
uniformly on top of the two
bottom bands so your
PlantHouse™ will fold into two
panels.
Step 4: Folding one panel on top of the other panel
your PlantHouse™ should be one flat panel. Shown
in Photos 4 & 5.
Step 5: Choosing the top corner, fold your
PlantHouse™ in half. You will feel the tension of the
spring steel. Continue folding under while you bring the
left side up and over. Your PlantHouse™ should
resemble a taco. See photos 6 & 7.

Self-erecting portable greenhouses Take Down Instructions
Page 2
Step 6: Continue folding
your PlantHouse™. Step 8: Fold the right side over the left side. Step 9: When finished your PlantHouse™ will
form 3 rings on top of
each other.
Step 10: Hold your PlantHouse™
between your knees to prevent it
from springing open. Begin to slide
the carry pack over your folded
PlantHouse™.
Step 11: Continue to
slide your PlantHouse™
into your carry
pack. Store the stakes in
their pouches and place,
along with your fiber pole
into the pack.
Now your ready
to take your
PlantHouse™
anywhere.
PlantHouse™ Parts List:
• 1 PlantHouse™ GreenHouse
PlantHouse 2'™ - Model # FHPH120
(28" high x 2' wide x 2' deep)
• 4 Ground Stakes
•1FiberPole
• Shade Cover
• Carry Pack
IMPORTANT:
• Before storing your PlantHouse™ GreenHouse, allow the
interior and exterior to dry completely to prevent mold and
mildew from growing. Growth of mold and/or mildew will
result in stains on the walls.
• Store your PlantHouse™ in a cool dry place.

Self-erecting portable greenhouses Set up Instructions
Page 1
Step 1: Remove
your PlantHouse™
from the pack.
Step 2: Allow your
PlantHouse™ to spring
open. CAUTION: Be
Sure to hold your
PlantHouse™ away
from your face as it
will Spring open.
Step 3: Unfold your
PlantHouse™ into 2
panels.
Step 4: Grab the
center steel band and
lift up to separate the
two sides of your
PlantHouse™. Smooth
and unfold the skirting.
Step 5: Assemble the
fiber pole provided.
Insert the capped ends
into the pockets above
the doorway and
opposite end.
Step 6: The doorway and
screen can be secured open
either together or
separate. Simply unzip the
doorway and/or screen. Roll
them long way. Secure with the
straps provided.
Attach your shade
cover for added
protection for nature's
harshest elements.

Self-erecting portable greenhouses Take Down Instructions
Page 1
Step 1: Begin first by
removing all of the stakes. It
may be easier for you to use
one take to remove another.
Step 2: Be sure your doors and
screens are zipped closed, then place
your PlantHouse™ on it's side and
remove the fiber pole from the ceiling.
Step 3: Push on the center
steel band. The two top
bands must be forced to lay
uniformly on top of the two
bottom bands so your
PlantHouse™ will fold into
two panels.
Step 4: Folding one panel on top of the other
panel your PlantHouse™ should be one flat
panel. Shown in Photos 4 & 5. Step 5: Choosing the top corner, fold your
PlantHouse™ in half. You will feel the tension of
the spring steel. Continue folding under while you
bring the left side up and over. Your
PlantHouse™ should resemble a taco. See
photos 6 & 7.
Step 6: Continue folding
your PlantHouse™.

Self-erecting portable greenhouses Take Down Instructions
Page 2
Step 8: Fold the
right side over the
left side.
Step 9: When
finished your
PlantHouse™ will
form 3 rings on top of
each other.
Step 10: Hold your
PlantHouse™ between
your knees to prevent
it from springing open.
Begin to slide the carry
pack over your folded
PlantHouse™.
Step 11: Continue to
slide your PlantHouse™
into your carry pack. Store
the stakes in their pouches
and place, along with your
fiber pole into the pack.
Now your ready to
take your
PlantHouse™
anywhere.
PlantHouse™ Parts List:
• 1 PlantHouse™ GreenHouse
PlantHouse 3'™ - Model # FHPH130
(3.5' high x 3' wide x 3' deep)
• 4 Ground Stakes
•1FiberPole
•ShadeCover
• Carry Pack
IMPORTANT:
• Before storing your PlantHouse™ GreenHouse, allow the
interior and exterior to dry completely to prevent mold and
mildew from growing. Growth of mold and/or mildew will
result in stains on the walls.
• Store your PlantHouse™ in a cool dry place.

Set up InstructionsSelf-erecting portable greenhouses
Page 1
Step 1: Remove your
PlantHouse™ from the
pack.
Step 2: Allow your
PlantHouse™ to spring
open. CAUTION: Be
Sure to hold your
PlantHouse™ away
from your face as it
will Spring open.
Step 3: Unfold your
PlantHouse™ into 2
panels.
Step 4: Grab the center
steel band and lift up to
separate the two sides
of your PlantHouse™.
Smooth and unfold the
skirting.
Step 5: Assemble
the fiber pole
provided. Insert the
capped ends into the
pockets above the
doorway and
opposite end.
Step 6: The doorway and
screen can be secured open
either together or
separate. Simply unzip the
doorway and/or screen. Roll
them long way. Secure with
the straps provided.
Attach your shade cover for
added protection for nature's
harshest elements.

Self-erecting portable greenhouses Take Down Instructions
Page 1
Step 1: Begin first by
removing all of the stakes. It
may be easier for you to use
one take to remove another.
Step 2: Be sure your doors and screens are
zipped closed, then place your PlantHouse™
on it's side and remove the fiber pole from the
ceiling.
Step 3: Push on the center
steel band. The two top bands
must be forced to lay
uniformly on top of the two
bottom bands so your
PlantHouse™ will fold into two
panels.
Step 4: Folding one panel on top of the
other panel your PlantHouse™ should be
one flat panel. Shown in Photos 4 & 5. Step 5: Choosing the top corner, fold your
PlantHouse™ in half. You will feel the tension
of the spring steel. Continue folding under
while you bring the left side up and
over. Your PlantHouse™ should resemble a
taco. See photos 6 & 7.
Step 6: Continue
folding your
PlantHouse™.

Self-erecting portable greenhouses Take Down Instructions
Page 2
Step 8: Fold the right side
over the left side. Step 9: When finished your PlantHouse™ will form 3
rings on top of each other.
Step 10: Hold your
PlantHouse™ between
your knees to prevent it
from springing open.
Begin to slide the carry
pack over your folded
PlantHouse™.
Step 11: Continue to
slide your PlantHouse™
into your carry
pack. Store the stakes
in their pouches and
place, along with your
fiber pole into the pack.
Now your ready to
take your
PlantHouse™
anywhere.
PlantHouse™ Parts List:
• 1 PlantHouse™ GreenHouse
PlantHouse 4'™ - Model # FHPH140
(56" high x 4' wide x 4' deep)
• 4 Ground Stakes
•1FiberPole
• Shade Cover
• Carry Pack
IMPORTANT:
• Before storing your PlantHouse™ GreenHouse, allow the
interior and exterior to dry completely to prevent mold and
mildew from growing. Growth of mold and/or mildew will
result in stains on the walls.
• Store your PlantHouse™ in a cool dry place.