Fluke 12 User manual

Network Time Machine
Quick Start Guide: Portable 1.2 Model
Your Network Time Machine (NTM) comes with the software already installed and licensed.
After you have unpacked it from its shipping container, proceed as follows:
1. Connect cables as shown in the figure below.
2. Turn on the AC power and wait for the computer to boot up. The power switch is located in
the upper right hand corner when facing the rear of the computer.
3. Start the NTM application by selecting Start > All Programs > ClearSight > ClearSight
Network Time Machine.
4. When the Login screen appears, click OK. No password is needed.
Connect one of these
Ethernet ports to your
control network for
remote operation of
this NTM using
Remote Desktop. Connect a USB
keyboard and
mouse here.
Connect the
power cable
here.
Connect these
Ethernet ports to the
network(s) from
which you want to
monitor, capture
frames, and perform
analysis.

©2010 Fluke Corporation. May 2010. All rights reserved. Printed in USA.
Contacting Fluke Networks
www.flukenetworks.com
[email protected]
[phone]
•Australia: 61 (2) 8850-3333 or 61 (3) 9329 0244
•Beijing: 86 (10) 6512-3435
•Brazil: 11 3759 7600
•Canada: 1-800-363-5853
•Europe: [phone]
•Hong Kong: 852 2721-3228
•Japan: 03-6714-3117
•Korea: 82 2 539-6311
•Singapore: 65-6799-5566
•Taiwan: (886) 2-227-83199
•USA: 1-800-283-5853
•Anywhere in the world: [phone]
Visit our website for a complete list of phone numbers.