Fluke PRUFTECHNIK DBS30 User manual

Parabolic sensor DBS30 pocket guide
Pocket guide
Accessories for the ultrasonic measuring
device SONOCHEK
Printed in Germany · LIT 06.102.12.17.en
Parabolic sensor
DBS30
Contents subject to change without further notice, particularly in the interest of further technical development.
Fluke Deutschland GmbH
Freisinger Str. 34
85737 Ismaning, Germany
+ 49 89 99616-0
www.pruftechnik.com
© Copyright 2017 by Fluke Corporation

Sensor elements
1
Parabolic mirror
2
Light spot target device (changes possible in the course
of device development, see the manufacturer's operating
instructions)
3
Parabolic mirror holder with set screw (on the back)
4
Handle with control and display elements
5
Status LED: Sensor on/off
6
Target laser on/off (press and hold the button)
7
Start/stop measurement recording
8
Integrated target laser
9
Ultrasonic microphone with acoustic horn
Sensor connections
1
Slot for sensor cable with marking of the plug-in position
2
USB port (only for service)
Operation of the parabolic sensor DBS30
1
2
3
Installation of the parabolic mirror
Hold the sensor handle with one hand and the parabolic mirror
on the parabolic mirror holder with the other so that the mirror
points in the test direction of the sensor.
Guide the parabolic mirror holder into the plug-in position on
the sensor from above and fasten it by turning the set screw.
Connecting the sensor to SONOCHEK
Connect the sensor to SONOCHEK according to the marking
using a sensor cable.
Operation using the buttons on the sensor
Starting and stopping the measurement can be checked
using the start/stop measurement recording function key. The
integrated target laser and the light spot target device help to
precisely localize the damaged points.
1
2
8
2
1
9
3
4
5
6
7
Eye injuries possible!
The target laser (laser class 2) can cause serious eye damage.
Never look into the laser beam.