FM 810A User manual

www.czfound.com [email protected]
www.foundmotor.com [e-mail]
1
LED Manual Control Panel
User Manual
Model: 810A
Operating Voltage: DC24V / DC36V / DC48V
Functions: Power Switch (Electric Door Lock)
Battery Level Indication
Three-Gear Motor Power Control
6km/h Inching Control
Light Switch
Auto-Hibernation after 10min Idleness
1. Exterior Parameters
Casing Material: ABS
Workable Temperature: -20 ℃-60 ℃with guaranteed mechanical
properties.
Front View Side View
Side View of the Support Stand

www.czfound.com [email protected]
www.foundmotor.com [e-mail]
2
2. User Instructions
Connections:
1. Connect the red wire to the positive.
2. Connect the black wire to the negative.
3. Connect the blue wire to the controller of the electric door
lock.
4. Connect the green wire to the controller of the motor
power intensity inching control wire.
5. Connect the yellow light to the positive.
6. Connect the white light to the negative.
1. Start
Press the button to power on the manual control panel, and the blue
wire connected to it will deliver the same output voltage as the power source.
The maximum operating current of the blue wire can reach 200mA.
2. Battery Level Indication
The LED indicators will show full bars when the
battery is fully charged. The LED indicator will start blinking
continuously at low battery, which indicates a battery recharge asap.
3. Motor Power Intensity Control
Please refer to this section as the control and indicating part of
the motor power intensity. The default intensity at boot is LOW, and the
corresponding output voltage is 1V. The control signal of the motor power
intensity will shift at each press of the mode button . The control
indicator will change from LOW to MED after pressing the mode button for the
first time, when the corresponding output voltage is 2V. The control indicator
will change from MED to HIGH after pressing the mode button for the second
time, when the corresponding output voltage is 3V. When pressing the mode

www.czfound.com [email protected]
www.foundmotor.com [e-mail]
3
button for the third time, the motor power indicator will be set back to LOW, and
the output power will be reset to 1V.
4. 6km/h Inching Control
Power on the panel and press the 6km button in any status to set the
output voltage of the motor power intensity wire to 4V, and the output will be
reset to the original when the button is released.
5. Light Control
Power on the panel and press the light button , the yellow wire will give
a positive voltage output (power input) and the light indicator will be on.
When pressing the light button for the second time, the voltage output
of the yellow wire will be cut off and the light indicator will be off.