FMI Outland Living Greenwood User manual

FMI BRANDS INC.
107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7 | Toll Free 1-888-514-1663 | Fax [phone]
D. OLVG-320.000.V0
Vertical Garden GREENWOOD
Model number OLVG-320
Owner’s Manual
GREENWO
OD

Owner & Safety Manual
D. OLVG-320.000.V0
En-1 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
Model number OLVG-320
NOTE TO INSTALLER:
Leave this guide with the consumer.
NOTE TO CONSUMER:
Please retain this guide for future use.
WARNING:
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Read the
installation, operating and maintenance instructions thoroughly
before installing or servicing this equipment.
CAUTION:
Watch for sharp edges.
Wear protective gloves if necessary.
SUPPLIED PARTS & HARDWARE LIST:
PART # DESCRIPTION PICTURE
APLANTER BIN
(x5)
BRIGHT TOP
FRAME (x1)
C
RIGHT
BOTTOM
FRAME (x1)
DLEFT TOP
FRAME (x1)

En-2
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SUPPLIED PARTS & HARDWARE LIST (continued):
PART # DESCRIPTION PICTURE
E
LEFT
BOTTOM
FRAME (x1)
F
RIGHT REAR
LEG FRAME
(x1)
G
LEFT REAR
LEG FRAME
(x1)
H
STRENGTH
CROSS BAR
(x2)
I
BIN HANGER
CROSS BAR
(x5)
PART # DESCRIPTION PICTURE
JWIRE BIN
SUPPORT (x5)
KM5 x 45 mm
SCREW (x2)
LM5 x 16 mm
SCREW (x6)
MM5 LOCK NUT
(x2)
NFOOTPAD (x4)
Wrapped in Orange Paper

Owner & Safety Manual
D. OLVG-320.000.V0
En-3 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY
STEP 1
BOTTOM FRAME:
Place (x1) LEFT BOTTOM FRAME, (x1) RIGHT
BOTTOM FRAME, (x1) STRENGTH CROSS BAR
(wrapped in ORANGE paper) and (x2) BIN HANGER
CROSS BARS on a flat work surface. Insert the
STRENGTH CROSS BAR into the bottom slot of the
LEFT BOTTOM FRAME. Then insert the two BIN
HANGER CROSS BARS into the upper two slots of the
LEFT BOTTOM FRAME. Align the slots of the RIGHT
BOTTOM FRAME with the cross bars and insert.
(x1) Strength Cross Bar
(x1) Strength Cross Bar
(x2) Bin Hanger Cross Bar
(x3) Bin Hanger Cross Bar
(x2) M5 x 16mm
Screw
(x2) M5 x 16mm Screw
(x1) Left Bottom Frame
(x1) Right Bottom Frame
(x1) Right Top Frame
(x1) Left Top Frame
(x1) Left Rear
Leg Frame
(x1) Right Rear
Leg Frame
STEP 2
TOP FRAME:
Place (x1) LEFT TOP FRAME, (x1) RIGHT TOP FRAME
and (x3) BIN HANGER CROSS BARS on a flat work
surface. Insert the three BIN HANGER CROSS BARS
into the three slots of the LEFT TOP FRAME. Align the
slots of the RIGHT TOP FRAME with the cross bars
and insert. Screw in (x2) M5 x 16mm SCREWS into the
cross bar on the TOP slot.
STEP 3
REAR LEG FRAME:
Place (x1) RIGHT REAR LEG FRAME, (x1) LEFT
REAR LEG FRAME and (x1) STRENGTH CROSS BAR
(wrapped in ORANGE paper) on a flat work surface.
Insert the STRENGTH CROSS BAR into the slot on the
LEFT REAR LEG FRAME. Align the slot of the RIGHT
REAR LEG FRAME with the STRENGTH CROSS BAR
and insert. Screw in (x2) M5 x 16mm SCREWS into the
STRENGTH CROSS BAR.

En-4
1-888-514-1663 | WWW.OUTLANDLIVING.COM
(x2) M5 x 16mm Screw
(x2)
M5 x 16mm
Screw
SECTION 1: ASSEMBLY (continued)
Bottom Frame
NOTE: M5 Lock Nuts go on the
inside of the frame.
Top Frame
Rear Leg
Frame
Bottom Frame
Rear Leg Frame
(x2) M5 Lock Nut
STEP 4
Stand the BOTTOM FRAME (From Step 1) and
affix the REAR LEG FRAME (from STEP 3) using
(x2) M5 x 45 mm SCREWS and (x2) M5 LOCK
NUTS. The M5 LOCK NUTS go on the inside of
the frame. DO NOT FULLY TIGHTEN the screws
and nuts in this step.
Use 8mm wrench (5/16”) for the M5 LOCK NUTS.
STEP 5
Insert the TOP FRAME (from STEP 2) into the
assembly from STEP 4. Affix the REAR LEG
FRAME to the TOP FRAME using (x2) M5 x
16 mm SCREWS. Then tighten the M5 LOCK
NUTS and the M5 x 45mm SCREWS from
STEP 4. Go around and check to confirm that
all the screws have been tightened before
proceeding to STEP 6.
ATTENTION:
Avoid pinching fingers when inserting TOP
FRAME into BOTTOM FRAME ASSEMBLY.

Owner & Safety Manual
D. OLVG-320.000.V0
En-5 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY (continued)
STEP 6
Insert (x5) WIRE BIN SUPPORTS into the hole on the cross
bars.
STEP 7
Stick on the (x4) FOOTPADS on the feet of the
Vertical Garden.
(x5) Wire Bin
Supports
(x4) Footpads

En-6
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 1: ASSEMBLY (continued)
STEP 8
Place (x5) PLASTIC BINS onto the WIRE BIN SUPPORTS and
the BIN HANGER CROSS BARS.
TIP: For ease of assembly, we suggest to start hanging the
bins from the bottom up.
ATTENTION: Avoid pinching fingers when placing PLANTER
BINS on WIRE BIN SUPPORTS and BIN HANGER CROSS
BARS.
STEP 9
Assembly is complete. Set the frame in the location where
you want to display it, before loading the frame with fully
loaded planter bins.
WARNING: Do not let children climb or hang on the vertical
garden, or injury or death may occur.
(x5) Planter Bin

Owner & Safety Manual
D. OLVG-320.000.V0
En-7 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
SOIL BUDGET/1 BIN SOIL BUDGET/5 BINS
0.4 cubic foot (ft3)2 cubic feet (ft3)
.02 cubic yard (yd3).1 cubic yard (yd3)
10.6 Imperial Quarts (qt) 53 Imperial Quarts (qt)
12 Litres (L) 60 Litres (L)
SECTION 2: PLANTER GARDENING
PLASTIC PLANTER BINS
The plastic bins are made from 100% new Polypropylene material
(PP) and are food safe (BPA free, phthalate free, lead free, mercury
free). The bins have a 3000hr UV stabilizer to protect the plastic
from degrading in the outdoors.
DRAIN HOLES
These bins do not come with drainage holes. Not everyone wants
drainage holes in their planters. But, if you want to add drainage
holes, we suggest using a 5/16” (8mm) drill bit (drill bit not included).
DRAINAGE LAYER
Some gardeners recommend placing approximately one inch of
drainage filler (pottery, shells, gravel, etc.) at the bottom of the
planter bin, before adding the soil. This is optional. The bottom of
the planter bins have raised feature denoting the drainage layer line.
TIP: Why add a drainage layer? Some people do
this to help prevent root rot. What this does is
create a small water reservoir below the
soil line. As the plant roots will prefer
to stay in the soil above, they won’t
sit in accumulated water where
they can potentially grow root
fungus. The water in the
lower drainage reservoir
will eventually evaporate up
through the soil, keeping the
soil moist.
Drainage
Layer Line
SOIL BUDGET ASSUMPTION:
Each planter bin is 555mmL x 205mmW x 150mmH
(22”L x 8”W x 6”H)
Add your preferred volume of Potting Soil Mix. (Soil not included).
Plan your budget for 12L (10.6 Quarts) of soil mix per bin and/or
adjust the volume of soil to suit your need.
22”
555mm
8”
205mm
6”
150mm
SECTION 1: ASSEMBLY (continued)

En-8
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 3: SET UP INSPECTION
SEQUENCE
The Vertical Garden should be inspected before use and at least
annually. More frequent cleaning and/or adjustments may be
required as necessary.
Prior to each use:
• Ensure placement is on a level and firm surface able to hold the
fully loaded weight of the frame, which is approximately
55-70Kg (120-150lb).
• Ensure no parts are missing and all fasteners are firmly
tightened.
SECTION 2: PLANTER GARDENING
(continued)
SECTION 4: MAINTENANCE
Your Outland Vertical Garden is meant for indoor or outdoor use
and requires periodic maintenance to keep it in good condition.
• Should any part of this appliance become soiled or dirty, wipe
down with a damp wet cloth. Use only water based cleaners.
• Check fasteners and ensure firmly tightened.
IMPORTANT: Do not use petroleum based, flammable or
corrosive cleaning products on or near this unit.
This appliance is NOT a toy.
WARNING:
Do not climb on the Vertical Garden or use it as a ladder or
serious injury, property damage and/or death may occur.
1” WATER RESERVOIR
To create a 1” water reservoir:
Option A: Drill a 5/16” (8mm) sized hole approximately 1-1/8 inch
up from the bottom of the bin, on the front face of the bin.
Option B: Drill a 5/16” (8mm) sized hole on the top of one of the
raised features located on the bottom of the planter bins.
If you require drainage but not a 1” water reservoir, simply drill a
5/16” (8mm) sized hole on the bottom of the planter bins.
Attention: Before drilling holes in the bins, consider that pesky
water may drip on the ground. TIP: Silicone tubing may be used to
direct the flow of water. (Silicone tubing not included.)
IMPORTANT
• Always ensure your Vertical Garden stands straight and level.
IMPORTANT
• Always ensure
all fasteners are
firmly tightened.

Owner & Safety Manual
D. OLVG-320.000.V0
En-9 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
SECTION 5: STORAGE
Your Vertical Garden has been designed to conveniently store away
when not in use.
• We recommend storing your Vertical Garden under cover
during winter, or when not in use.
Follow these instructions to ready for storage:
• Remove plastic Planter Bins from frame.
• Remove Rear Legs.
• Store conveniently. See you next season.
APPROXIMATE DIMENSIONS
25”
638mm
29”
731mm
48”
1227mm
FRONT SIDE
The Vertical Garden measures approximately 48” High and stands in a compact footprint of 25” Wide x 29” Deep.
(1227mmH x 638mmW x 731mmD)

En-10
1-888-514-1663 | WWW.OUTLANDLIVING.COM
NOTES
1. The Vertical Garden measures approximately
48” High and stands in a compact footprint of 25” Wide x 29”
Deep. (1227mmH x 638mmW x 731mmD)
2. The planter bins are 6” (150mm) Deep.
3. This list of recommended crops for your Vertical Garden is by
no means complete, but should help provide some ideas to start
your green thumb:
• Lettuce (leaf varieties)
• Spinach
• Radish
• Baby Carrots
• Beets
• Onions (Green, Scallion)
• Asian Greens (Tatsoi, Pak
Choy, Mizuna, Gai-lon)
• Herbs (Basil, Thyme,
Tarragon, Rosemary,
Oregano, Cilantro, Dill,
Savory, Mint, Sage, Chives,
Bay, Parsley, Coriander,
Sorrel, Lemongrass)
4. Here is a list of Annuals flowers which you may like to try in your
Vertical Garden:
Note that plants grown in containers typically need to be watered
more frequently than plants grown in the ground. We recommend
monitoring your soil moisture and water regularly.
For best results, consult your local nursery for gardening tips when
purchasing your garden materials.
• Alyssum
• Begonia
• Browallia
• Coleus
• Geraniums
• Impatiens
• Latana
• Lobelia
• Marigolds
• Periwinkle
• Nasturtiums
• Pansies
• Petunias
• Salvia
• Sanvitalia
• Snapdragons
• Thunbergia
• Zinnias
1 YEAR LIMITED WARRANTY
Customers in Canada and USA
All components are warranted by the manufacturer for a period of 1 year after date of purchase
by the original owner against defects in materials and workmanship under normal use. This
warranty does NOT cover normal wear and weathering, assembly and/or maintenance OR use in a
commercial application. At FMI Brands’ sole discretion, products under warranty will be repaired
and/or replaced at no charge to the customer. Any returns sent back to FMI Brands must be sent via
prepaid freight and in the original retail packaging.
Please register your OUTLAND Living product for proof of purchase and warranty at
https://outlandliving.com/register-products/
For more warranty information and details please contact FMI Brands Inc. at
[e-mail]

Owner & Safety Manual
D. OLVG-320.000.V0
E n -11 OUTLAND LIVING VERTICAL GARDEN OWNER & SAFETY MANUAL
FOR REPLACEMENT PARTS AND ACCESSORIES PLEASE VISIT
WWW.OUTLANDLIVING.COM
The owner’s manual is available as a free download from www.outlandliving.com
Replacement part orders can be sent by mail to the address on the cover of this booklet, or faxed to [phone]. Should you have any questions
or comments regarding this product, please do not hesitate to contact FMI Brands Inc. at [phone] or E-Mail to in[email protected].
STOP
Do not return this product to the store.
If you need help or parts, call the OUTLAND Hotline: [phone]
Get help for:
Missing/damaged parts • Assembly • Troubleshooting
• Warranty Assistance • Product Information