FMI OUTLAND LIVING OUTDOOR LIVING PERFECTED... User manual

FMI BRANDS INC. 107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7
Toll Free: 1-888-514-1663 | Tel: [phone] | Email: [e-mail]
D. OLVG-302.000.V3
Vertical Garden TERRACE
Model number OLVG-302
Owner’s Manual
TERRACE

Owner & Safety Manual
D. OLVG-302.000.V3
En-1 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
Model number OLVG-302
NOTE TO INSTALLER:
Leave this guide with the consumer.
NOTE TO CONSUMER:
Please retain this guide for future use.
WARNING:
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Read the
installation, operating and maintenance instructions thoroughly
before installing or servicing this equipment.
CAUTION:
Watch for sharp edges.
Wear protective gloves if necessary.
SUPPLIED PARTS & HARDWARE LIST:
PART # DESCRIPTION PICTURE
1 RIGHT TOP
FRAME (x1)
2
RIGHT
BOTTOM
FRAME (x1)
3 LEFT TOP
FRAME (x1)
4 LEFT BOTTOM
FRAME (x1)

En-2
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SUPPLIED PARTS & HARDWARE LIST (continued):
PART # DESCRIPTION PICTURE
5 CROSS BARS
(x3)
6 REAR LEGS
(x2)
7 BIN HANGER
(x8)
8M5 x 45mm
SCREW (x14)
PART # DESCRIPTION PICTURE
9 M5 x 16mm
SCREW (x2)
10 M5 LOCK NUT
(x2)
11
PLASTIC
PLANTER BIN
(x4)
12 BLACK PLASTIC
SPACER (x8)
REQUIRED TOOLS:
• Philips (cross) screw driver (PH2)
• 8mm wrench (5/16”)

Owner & Safety Manual
D. OLVG-302.000.V3
En-3 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY
STEP 1
BOTTOM FRAME:
Place the LEFT BOTTOM FRAME, the RIGHT
BOTTOM FRAME and one CROSS BAR on a flat
work surface. Ensure that the bin hanger support
pegs are facing inwards. Align the Cross Bar with
the screw holes and affix tightly with(x4) M5 x
45mm SCREWS.
Support Pegs
Facing In
Cross Bar
Cross Bar
Cross Bar
Rear Leg
M5 x 45mm
Screw (x2)
M5 x 45mm
Screw (x2)
M5 x 45mm
Screw (x2)
Support Pegs
Facing In
Left Bottom Frame
Left Top
Frame
BOTTOM FRAME
TOP FRAME
REAR LEG FRAME
Right
Bottom
Frame
Right Top Frame
STEP 2
TOP FRAME:
Place the LEFT TOP FRAME, the RIGHT
TOP FRAME and one CROSS BAR on
a flat work surface. Ensure that the bin
hanger support pegs are facing inwards.
Align the Cross Bar with the screw holes
and affix tightly with(x4) M5 x 45mm
SCREWS.
STEP 3
REAR LEG FRAME:
Place the REAR LEGS and the last CROSS BAR
on a flat work surface. Align the screw holes
and tightly screw in (x4) M5 x 45mm SCREWS.

En-4
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 1: ASSEMBLY (continued)
Bottom Frame
NOTE: M5 Lock
Nuts go on the
inside of the frame.
Top Frame
Rear Leg
Frame
Bottom Frame
Rear
Leg
Frame
M5 x 45
Screws (x2)
M5 x 16mm
Screw (x2)
M5 Lock
Nuts (x2)
M5 Lock
Nuts (x2)
STEP 4
Stand the BOTTOM FRAME (from STEP 1) and affix
the REAR LEG FRAME (from STEP 3) using (x2) M5
x 45mm SCREWS and (x2) M5 LOCK NUTS. The
M5 LOCK NUTS go on the inside of the frame. DO
NOT FULLY TIGHTEN the screws and nuts in this
step.
Use 8mm wrench (5/16”) for the M5 LOCK NUTS.
STEP 5
Insert the TOP FRAME (from STEP 2) into the
assembly from STEP 4. Affix the REAR LEG
FRAME to the TOP FRAME using (x2) M5
x 16mm SCREWS. Then tighten the LOCK
NUTS and the M5 x 45mm SCREWS from
STEP 4. Go around and check to confirm that
all the screws have been tightened before
proceeding to STEP 6.

Owner & Safety Manual
D. OLVG-302.000.V3
En-5 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
SECTION 1: ASSEMBLY (continued)
STEP 6
Place (x8) BLACK PLASTIC SPACERS on the bin hanger
support pegs.
STEP 7
Place (x8) BIN HANGERS onto the bin hanger support pegs.
Black Plastic Spacers (x8)
Bin Hanger (x8)
Bin Hanger (x8)
Black
Plastic
Spacers
(x8)

En-6
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 1: ASSEMBLY (continued)
STEP 8
Place (x8) PLASTIC PLANTER BINS onto the BIN HANGERS.
STEP 9
Assembly is complete. Set the frame in the location where
you want to display it, before loading the frame with fully
loaded planter bins.
Your OUTLAND Vertical Garden is ready to use indoors or
outdoors.
IMPORTANT: Always ensure your Vertical Garden stands straight
and level.
IMPORTANT: Always ensure all fasteners are firmly tightened.
Plastic Planter Bin (x4)

Owner & Safety Manual
D. OLVG-302.000.V3
En -7 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
APPROXIMATE DIMENSIONS
30”
760mm
24”
610mm
FRONT
GROUND
SIDE
65”
1650mm
WALL
The Vertical Garden frame measures approximately: 30”W x 24”D x 65”H (760mmW x 610mmD x 1650mmH).

En-8
1-888-514-1663 | WWW.OUTLANDLIVING.COM
PLASTIC PLANTER BINS
The plastic bins are made from 100% new Polypropylene material
(PP) and are food safe (BPA free, phthalate free, lead free, mercury
free). The bins have a 3000hr UV stabilizer to protect the plastic
from degrading in the outdoors.
DRAINAGE LAYER
Some gardeners recommend placing approximately one inch of
drainage filler (pottery, shells, gravel, etc.) at the bottom of the
planter bin, before adding the soil. This is optional. The bottom of
the planter bins have raised feature denoting the drainage layer
line.
TIP: Why add a drainage layer? Some people do this to help prevent
root rot. What this does is create a small water reservoir below
the soil line. As the plant roots will prefer to stay in the soil above,
they won’t sit in accumulated water where they can potentially
grow root fungus. The water in the lower drainage reservoir will
eventually evaporate up through the soil, keeping the soil moist.
DRAIN HOLES
These bins do not come with drainage holes. Not everyone wants
drainage holes in their planters. But, if you want to add drainage
holes, we suggest using a 5/16” (8mm) drill bit (drill bit not
included).
Attention: Before drilling holes in the bins, consider that pesky
water may drip on the ground. TIP: Silicone tubing may be used to
direct the flow of water. (Silicone tubing not included.)
SECTION 2: PLANTER GARDENING
1” WATER RESERVOIR
To create a 1” water reservoir:
Option A: Drill a 5/16” (8mm) sized hole approximately 1 inch up
from the bottom of the bin, on the front face of the bin.
Option B: Drill a 5/16” (8mm) sized
hole on the top of one of the raised
features located on the bottom of
the planter bins.
Drainage
Layer Line
5/16” (8mm)
Drill Hole
5/16”
(8mm)
Drill Hole
5/16”
(8mm)
Drill Hole
If you require drainage but not a 1” water
reservoir, simply drill a 5/16” (8mm)
sized hole on the bottom of the
planter bins.

Owner & Safety Manual
D. OLVG-302.000.V3
En-9 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
26.5”
675mm
9.5”
242mm
8”
205mm
SECTION 2: PLANTER GARDENING (continued)
SOIL BUDGET ASSUMPTION:
The dimensions of the planter bins are approximately
26.5”L x 9.5”W x 8”H (675mmL x 242mmW x 205mmH)
Add your preferred volume of Potting Soil Mix. (Soil not included).
Plan your budget for 28L (25 Quarts) of soil mix per bin and/or
adjust the volume of soil to suit your need.
SOIL BUDGET/1 BIN SOIL BUDGET/4 BINS
1 cubic foot (ft3)4 cubic feet (ft3)
.04 cubic yard (yd3).15 cubic yard (yd3)
25 Imperial Quarts 100 Imperial Quarts
28 Litres (L) 113 Litres (L)
WATERING FEATURE
The OUTLAND Living vertical garden planter bins will rotate on the
support pegs to make watering your plants easy and convenient.
CAUTION:
Do not tip the planter so far up that the bins fall out!
FEATURE: ROTATING BINS
MAKE WATERING EASY
AND CONVENIENT

En-10
1-888-514-1663 | WWW.OUTLANDLIVING.COM
SECTION 3: SET UP INSPECTION
SEQUENCE
The Vertical Garden should be inspected before use and at least
annually. More frequent cleaning and/or adjustments may be
required as necessary.
Prior to each use:
• Ensure placement is on a level and firm surface able to hold the
fully loaded weight of the frame, which is approximately
60-70Kg (130-160lb).
• Ensure no parts are missing and all fasteners are firmly
tightened.
SECTION 4: MAINTENANCE
Your Outland Vertical Garden is meant for indoor or outdoor use
and requires periodic maintenance to keep it in good condition.
• Should any part of this appliance become soiled or dirty, wipe
down with a damp wet cloth.
IMPORTANT: Do not use petroleum based, flammable or
corrosive cleaning products on or near this unit.
This appliance is NOT a toy.
WARNING:
Do not climb on the Vertical Garden or use it as a ladder or
serious injury, property damage and/or death may occur.
WARNING:
Do not drag or push the Vertical Garden with fully loaded
planter bins! At worst, the frame could fall, causing serious
injury, or death. At minimum, it could damage your floors.
Always remove the planter bins before moving the frame.
SECTION 5: STORAGE
Your Vertical Garden has been designed to conveniently store away
when not in use.
• We recommend to store your Vertical Garden under cover
during winter, or when not in use.
Follow these instructions to ready for storage:
• Remove plastic Planter Bins from frame.
• Set aside the bin hanger brackets.
• Remove Rear Legs.
• Store conveniently. See you next season.
IDEAS FOR WHAT TO GROW
THIS LIST OF RECOMMENDED CROPS FOR YOUR
VERTICAL GARDEN IS BY NO MEANS COMPLETE,
BUT SHOULD HELP PROVIDE SOME IDEAS TO START
YOUR GREEN THUMB:
HERE IS A LIST OF ANNUALS FLOWERS WHICH YOU
MAY LIKE TO TRY IN YOUR VERTICAL GARDEN:
Note that plants grown in containers typically need to be watered
more frequently than plants grown in the ground. We recommend
to monitor your soil moisture and water regularly.
For best results, consult your local nursery for gardening tips when
purchasing your garden materials.
• Lettuce (leaf varieties)
• Spinach
• Radish
• Arugula
• Baby Carrots
• Beets
• Chard
• Onions (Green, Scallion)
• Asian Greens (Tatsoi, Pak
Choy, Mizuna, Gai-lon)
• Determinate (bush) tomato
plants (small cherry
tomatoes, salad varieties)
• Herbs (Basil, Thyme,
Tarragon, Rosemary,
Oregano, Cilantro, Dill,
Savory, Mint, Sage, Chives,
Bay, Parsley, Coriander,
Sorrel, Lemongrass)
• Alyssum
• Begonia
• Browallia
• Coleus
• Geraniums
• Impatiens
• Latana
• Lobelia
• Marigolds
• Periwinkle
• Nasturtiums
• Pansies
• Petunias
• Salvia
• Sanvitalia
• Snapdragons
• Thunbergia
• Zinnias

Owner & Safety Manual
D. OLVG-302.000.V3
E n -11 OUTLAND LIVING - TERRACE VERTICAL GARDEN OWNER & SAFETY MANUAL
STOP:
Do not return this product to the store.
If you need help or parts, call the OUTLAND Hotline: [phone]
Get help for:
Missing/damaged parts • Assembly • Troubleshooting • Warranty Assistance • Product Information
1 YEAR LIMITED WARRANTY
Customers in Canada and USA
All components are warranted by the manufacturer for a period of 1 year after date of purchase by
the original owner against defects in materials and workmanship under normal use. This warranty
does NOT cover normal wear and weathering, assembly and/or maintenance OR use in a commercial
application. At FMI Brands’ sole discretion, products under warranty will be repaired and/or replaced
at no charge to the customer. Any returns sent back to FMI Brands must be sent via prepaid freight
and in the original retail packaging.
Please register your OUTLAND Living product for proof of purchase and warranty at
https://outlandliving.com/register-products/
For more warranty information and details please contact FMI Brands Inc. at [e-mail]
FOR REPLACEMENT PARTS AND ACCESSORIES PLEASE VISIT
WWW.OUTLANDLIVING.COM
The owner’s manual is available as a free download from www.outlandliving.com
Should you have any questions or comments regarding this product, please do not hesitate to contact FMI Brands Inc. at [phone] or
E-Mail to [email protected].