Forever Redwood THE VICTORIAN TRELLIS User manual

ASSEMBLY INSTRUCTIONS FOR
THE VICTORIAN TRELLIS
866.332.2403 (TOLL FREE); 7am –7pm Pacific Time, Monday-Saturday

P| 1
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
CONTENT OF BOXES
No.
1
2
3
4
5
6
7
8
9
Drawing
Description
Posts
Lateral Posts with Trims
Lateral Posts
Lateral Arches
Wall Trellis
Long Supports
Short Supports
Small Arc
Perimeter Arches
Qty.
6
6
6
3
13
2
2
1
2
Note: Part numbers in the Content of Boxes Table are for reference only. These do not match to the numbers marked on the parts sent.

P| 2
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
CONTENT OF BOXES
No.
10
11
12
13
14
15
16
17
Drawing
Hurricane
Gale Wind
Standard
Description
Arc Support
Arc Trellis
Roof Trellis
Arches
Roof Fascia
Boots
Angles
Standard, Gale Wind or
Hurricane Anchors Bases.
If ordered.
Qty.
1
2
58
9
1
18
14
4
Note: Part numbers in the Content of Boxes Table are for reference only. These do not match to the numbers marked on the parts sent.

P| 3
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
CONTENT OF BOXES
No.
A
B
C
D
E
F
G
H
I
J
Drawing
Description
½´´ X 4´´ Anchor Bolts
(To attach the anchor bases and the angles to the ground).
5/16´´ X 3´´ Lag Bolts
(To attach the anchor bases and the wall trellis to the posts. /
To attach the wall trellis to the supports).
3/8´´ X 6´´ Bolts
(To attach the lateral arches to the lateral posts with trims).
3´´ Deck Screws +
(To attach the post to the angles. / To attach the boots to the
posts).
3/8´´ X 9´´ Bolts
(To attach the supports to the lateral arches).
3/8´´ X 8´´ Lag Bolts with Washers
(To attach the short supports to the post and to the long
supports. / To attach the long supports to the posts. / To attach
the arc support to the frontal arches).
3/8´´ X 6´´ Lag Bolts
(To attach the long supports to the posts)
5/16´´ X 3 ½´´ Bolts
(To attach the small arc to the posts. / To attach the half arches
and the frontal arc to the posts).
3´´ Deck Screw □
(To attach the arc trellis to the frontal arches. / To attach the
roof trellis together, to the arches and to the long supports. / To
attach the arch fascia to the frontal arc).
4´´ Deck Screws +
(To attach the arches to the long supports).
Note: Dimensions of your hardware will vary depending on size.

P| 4
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
No.
.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
7DESCRIPTION
Posts
Lateral Posts with Trims
Lateral Posts
Lateral Arches
Wall Trellis
Long Supports
Short Supports
Small Arc
Frontal Arc
Arc Support
Arc Trellis
Roof Trellis
Arches
Roof Fascia
Boots
Angles
Anchor Bases
Note: Part numbers in the Drawing are for reference only. These do not match to the numbers marked on the parts sent.

P| 5
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
NOTE: In order to know where the post needs to be placed, check the numbers on them. If the post is not marked, then place the
single Supports on the ground to locate the markings for each post position and clearly set your bearings. (“Don´t attach yet, only
place them on the ground to begin with”).
Step 1: Install the angles (16) and the anchor bases (17) with ½´´ X 4´´ anchor bolts (A) or lag bolts. Please see the “How to
anchor your pergola document” for all details. Set your perimeter post (1) in the saddle of the anchor bases (17). Drill a ø ¼´´
hole in the post prior to anchoring to facilitate the ratcheting of the hardware. After that, use a 5/16´´ X 3´´ lag bolts (b) to attach
each post to the its respective anchor base (17).
1
1
1
1
17
5/16´´ X 3´´ Lag Bolts
17
16
17
17

P| 6
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 2: Use 3/8´´ x 6´´ bolts (C) to attach the lateral arches (4) to the lateral posts with trims (2). Each part has a series of numbers
that indicate where to attach the part with the corresponding number.
2
2
2
4
2
4
3/8´´ X 6´´ Bolts

P| 7
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 3: Attach the wall trellis, the posts and the posts with arches, as shown below.
Step 3 .1: Use 5/16´´ x 3´´ lag bolts (B) and washers to attach the wall trellis (5) to the posts. Each part has a series of numbers
that indicate where to attach the part with the corresponding number.
5
5/16´´ X 3´´ Lag Bolts
5

P| 8
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 3.2: Use 3´´ deck screws + (D) to attach the posts to the angles. After that, attach the post to the trellis with 5/16´´ x 3´´´lag
bolts (B) and washers. Each part has a series of numbers that indicate where to attach the part with the corresponding number.
3´´ Deck Screws
5/16´´ X 3´´ Lag Bolts

P| 9
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Repeat the operation until the installation is complete.

P| 10
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 4: Attach the long supports (6) and the short supports (7) to the trellis with 5/16´´ x 3´´ lag bolts with washers (B) and to the
lateral arches with 3/8´´ x 9´´ bolts (E). Each part has a series of numbers that indicate where to attach the part with the
corresponding number.
5/16´´ X 3´´ Lag Bolts
3/8´´ X 9´´ Bolts
6
7
7
6

P| 11
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 5: Use 3/8´´ x 8´´ lag bolts (F) and washers to attach the short supports (7) to the posts and to the long supports (6). After
that, attach the long supports (6) to the posts with 3/8´´ x 6´´ lag bolts (G) and 3/8´´ x 8´´ Lag bolts (F) with Washers, as shown
below. Each part has a series of numbers that indicate where to attach the part with the corresponding number.
3/8´´ X 6´´ Lag Bolts
3/8´´ X 8´´ Lag Bolts
6
3/8´´ X 8´´ Lag Bolts
3/8´´ X 8´´ Lag Bolts
Long Supports
Short Supports
6
7
7

P| 12
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 6: Use 5/16´´ x 3 ½´´ Bolts (H) to attach the small arc (8) to the posts. Each part has a series of numbers that indicate where
to attach the part with the corresponding number.
Step 7: Use 5/16´´ x 3 ½´´ Bolts (H) to attach the perimeter arches (9) to the posts. Each part has a series of numbers that indicate
where to attach the part with the corresponding number.
5/16´´ X 3 ½´´ Bolts
8
9
5/16´´ X 3 ½´´ Bolts
9

P| 13
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 8: Attach the arc support (10)to the frontal arches with 3/8´´ x 8´´ lag bolts (F). Each part has a series of numbers that
indicate where to attach the part with the corresponding number.
10
3/8´´ X 8´´ Lag Bolts

P| 14
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 9: Use 3´´ Deck Screws □(I) to attach the arc trellis (11) to the frontal arches. Each part has a series of numbers that indicate
where to attach the part with the corresponding number.
11
3´´ Deck Screw □
11

P| 15
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 10: Attach the arches and the trellis, as shown below.
Step 10.1: Attach a row of roof trellis (12) together and to the frontal arc with 3´´ deck screws □ (I). After that attach to the long
supports with 3´´ deck screws □ (I). Each part has a series of numbers that indicate where to attach the part with the corresponding
number.
12
3´´ Deck Screws □
3´´ Deck Screws □

P| 16
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 10.2: Attach an arc (13) to the trellis with 3´´ deck screws □ (I). After that, attach to the long supports with 4´´ deck screws+
(J). Each part has a series of numbers that indicate where to attach the part with the corresponding number.
3´´ Deck Screws □
4´´ Deck Screws +
13

P| 17
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Repeat the operation until the installation is complete.
Step 11: Use 3´´ deck screws □ (I) to attach the arc fascia (14) to the frontal arc.
3´´ Deck Screws □
14

P| 18
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
Step 11: Finally, use 3´´ deck screws + (D) to attach the boots (15) to each posts.
3´´ Deck Screws +
15

P| 19
THE VICTORIAN TRELLIS
www.ForeverRedwood.com
This completes The Victorian Trellis assembly. Hope you enjoy your set for many decades. If you ever have a problem or a
question, don't hesitate to call us (866 332 2403) or email us. We are here to support you.