FOURSTEEL STEEL GLAM User manual

1
2020 07 - 05
WARNING !
STEEL GLAM INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read All Instructions.
WARNING - This appliance is not intended for installation in a shower or near a water
spray.
IMPORTANT- The installation and all electrical connections of this appliance should be
carried out by an approved professional in accordance with the National Electric Code
and Local Codes.
Use the appliance only as described in this manual. The manufacturer declines
responsibility for any damages, re, shock or injury to persons resulting from any other
not recommended use.
To ensure the appliance is mounted securely, fasteners should be secured in studs, or
alternatively, in structural members that are placed behind the plasterboard.
Extreme caution is necessary when any heater is used by or near children or invalids and
whenever heaters are left operating and unattended.
If the power cord is damaged, it must be replaced by the manufacturer, by theTechnical
Assistance Service or by qualied professional in order to avoid possible risks.
It is the responsibility of the installer to inspect for any damage when the box is opened.
Shipping damage should be reported immediately to your reseller or the
manufacturer.
Regulations require that only approved professional carry out electrical work.
For your own safety and others, ensure this is done.
IMPORTANT SAFETY INSTRUCTIONS:
When using electrical appliances, basic precautions should always be followed to
reduce the risk of re, electric shock and injury to persons, including:
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
READ AND FOLLOW ALL INSTRUCTIONS
WARNING - This unit is not intended for installation in a shower or near a water spray.
IMPORTANT - All electrical connections must be carried out by a licensed
electrician in accordance with LOCAL ELECTRICAL CODES OR NATIONAL CODES.
Use this towel warmer only as described in this manual. The manufacturer declines
responsibility for any damages, re, shock or injury to persons resulting from any
other not recommended use.
To ensure the towel warmer is mounted securely, fasteners should be secured in
studs, or alternatively, in structural members that are placed behind the rails.
Extreme caution is necessary when any heater is used by or near children or invalids
and whenever heaters are left operating and unattended.
Do not operate any heater with a damaged cord or after the heater malfunctions, or
has been damaged in any manner. Return the towel warmer to an authorized service
facility for examination, electrical or mechanical adjustment, or repair.
It is the responsibility of the installer to inspect for any damage when the box is
opened. Shipping damage should be reported immediately to your reseller or the
factory.
Regulations require that only authorized persons carry out electrical work. For your
own safety and that of others, ensure this is done.
Use this appliance only on the voltage specied on the rating plate, or elsewhere in
the instructions.
IMPORTANT SAFETY INSTRUCTIONS:
When using electrical appliances, basic precautions should always be followed to
reduce the risk of re, electric shock and injury to persons, including:

2
Children aged from 3 years and less than 8 years shall only switch on/o the appliance
provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate and clean
the appliance or perform user maintenance.
Please check that the voltage in the rating label ts the power supply.
Disconnection means must be integrated into the electrical wiring in accordance with
electrical installation standards.
Do not stand, hang or sit on the appliance.
The appliance is intended for home use only.
Please allow a minimum of 30 minutes for the appliance to heat up.
The basic operation of this appliance is to warm towels. It is not designed as a primary
heat source.
The temperature of the appliance may vary during usage (electric heating element
with thermostatic sensor).
The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance
by a person responsible for their safety.
Children under the age of 3 years should not be allowed within close proximity of the
appliance without the supervision of an adult.
Children must not play with the appliance.
Cleaning and user maintenance must not be made by children without supervision.
CAUTION — Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.
SAVE THESE INSTRUCTIONS
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
Be assured that the system is installed with a dierential switch with electric current ≤
30mA.
Do not stand, hang or sit on the towel warmer.
The towel warmer is for inside use only.
Please allow a minimum of 30 minutes for the towel warmer to heat up.
The towel warmer basic operation is to warm towels. It is not designed as a primary
heat source.
The temperature of the units may vary during usage (electric heating element with
built-in thermostatic sensor).
The towel warmer will be hot. Please ensure children and the elderly are supervised
at all times in the towel warmer vicinity.
SAVE THESE INSTRUCTIONS.

3
This product was developed to provide a simple, secure and comfortable usage.
These instructions must be taken into account for the correct use of the equipment.
USER’S MANUAL
MODEL : STEEL GLAM
ELECTRIC VERSION
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
REPAIR OF DAMAGES
In case of an emergency or damage, switch o the device and contact your reseller. Do not attempt
to repair the unit yourself, otherwise this will be considered as a breach of the warranty provisions.
GUARANTEE
The warranty for this product is 2 years on presentation of the corresponding invoice.
MAINTENANCE
When cleaning the radiator use a soft damp cloth only. Never use use soap-based detergents,
abrasive cleaners or detergents containing ammonia and other acids for cleaning and maintenance.
DISPOSAL OF THE EQUIPMENT
This product must be disposed of pursuant the valid legal provisions and separated from domestic
waste. Please dispose of this product by bringing it to your local
collection point or recycling centre of such equipment. Recycling contributes to reducing CO²
emissions and thus to the protection of the environment.
CONTACTS
www.foursteel.eu
[email protected]
T. [phone] | [phone]
Foursteel - Heating Products Factory
C.E.A. Zona Industrial de Mamodeiro
3810 - 783 Aveiro
Portugal
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
USER’S MANUAL
MODEL : STEEL GLAM
ELECTRIC VERSION
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED

24’’
60cm
60cm24’’
4
Verify if you have the requested product.
Make sure the electric element is in the correct side of
the wall, right or left, according to the room's electric
installation.
You must pay attention to the correct placement of the
towel rail in the wall.
Possible positions: only vertical (see g. 2).
The placement of this equipment should respect the
minimum safety distance (see g. 1).
BEFORE INSTALLATION
Bathtub or
shower area
hidden electric element II
HIDDEN ELECTRIC ELEMENT II
fig 1 : Minimum safety distance.
HIDDEN ELECTRIC ELEMENT II
Electrical element
on bottom
Electrical element
on the right
Electrical element
on the left
Electrical element
on top
fig 2 : Possible application of the towel warmer. Correct placement position.
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
TECHNICAL CHARACTERISTICS
power supply – AC 230-240V, 50Hz
protection class – class II
Ingress Protection Rating – IP 64
Material - Stainless Steel AISI 304
Glycol - Bio RH20
IEC 60335-2-43:2017
EN 60335-2-43:2003 + A1:2006 + A2:2008
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
TECHNICAL CHARACTERISTICS
power supply – AC 110V / 120V, 60Hz
UL 499 - Electric Heating Appliances
CSA C22.2 No.64 - Household Cooking
and Liquid Heating Appliances
Material - Stainless Steel AISI 304
Glycol - Bio RH20
BEFORE INSTALLATION
Bathtub or
shower area
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
Verify if you have the requested product. Make sure the
electric element is in the correct side of the wall.
You must pay attention to the correct placement of the
towel rail in the wall. Possible postion: Vertical only with
electrical element on bottom (see g. 2).
The placement of this equipment should respect the
minimum safety distance (see g. 1).
fig 1 : Minimum safety distance.
fig 2 : Possible application of the towel warmer. Correct placement position.
HIDDEN ELECTRIC ELEMENT II

(d) (e) (f)
(a) (b) (c)
5
x3
support
screws
x1
support
x6
headless
screws M4
x2
top supports
45 x 25mm
x1
bottom support
47 x 65 x 65mm
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
x3
plastic plug
MATERIAL
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
(d)
(h)
(e) (f) (g)
(a) (b) (c)
x3
support
screws
x2
wall plate
screws M3
x6
headless
screws M4
x2
top supports
45 x 25mm
x1
bottom support
47 x 65 x 65mm
x1
wall plate
MATERIAL
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
x3
plastic plug
x4
headless
screws M4

6
1
Decide where to install the unit and the location of the junction box.
This can be done by either placing the assembled towel warmer against the wall or taking
measurements from the towel warmer supports.
Mark in the wall, the xing points for the wall supports (a) (b).
anchor point
anchor point
anchor point electric cable exit
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
16”(406mm)
stud
2’’x4’’
stud
2’’x4’’
INSTALLATION (Installation by a trained certied technician)
Junction Box 2’’ x 4’’
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED

5
4
(e)
(f)
(f)
(c)
(a)
(a)
(b)
7
6
3
2
(e)
2.1
(c)
electric cable
Apply the two top supports (a) and the left down support (b) by fasten the support screws (e)
to the wall.
Pass the electric cable through the support
and the cover plate (c) into the wall junction
box.
Apply the support (c) to the bottom of the
towel warmer with the 2 headless screw (f)
provided.
Securely hand-tighten each of the three
headless screws M4 (f) on the towel warmer
supports location.
Place the radiator on the wall supports.
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
5
4
(f)
(g)
(g)
(h)
(a)
(a) (b)
(c)
6
3
2
(f)
2.1
electric cable
Junction Box 2’’ x 4’’
Apply the two top supports (a) and the left down support (b) by fasten the support screws (f)
to the wall.
Pass the electric cable through the support
and the cover plate (c) into the wall junction
box.
Apply the support (h) to the bottom of the
towel warmer with the 2 headless screw (g)
provided.
Securely hand-tighten each of the three
headless screws M4 (g) on the towel warmer
supports location.
Place the towel warmer on the wall supports.
stud
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED

8
7
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
OPERATION
electric connection of the towel warmer:
TOWEL
WARMER
STANDARD WIRE COLOURS FOR FLEXIBLE CABLESTANDARD WIRE COLOURS FOR FLEXIBLE CABLE
brown - Phase blue - Neutral
brown - Phase
blue - Neutral
brown - Phase
blue - Neutral
junction box
NOT PROVIDED
BY FOURSTEEL
230-240V
Make the electric connections of the towel warmer. The connection should be made to a
power supply of 230-240V/50Hz. Make a certied prossional wire the towel warmer to the
electrical circuit according to the gure.
FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL
© Foursteel, Aveiro, 2020, all rights reserved
OPERATION
electric connection of the towel warmer:
TOWEL
WARMER
Junction Box 2’’ x 4’’
black - Phase
black - Phase
STANDARD WIRE COLOURS FOR FLEXIBLE CABLE
white - Neutral
white - Neutral
green - Protective Earth
green - Protective Earth
black - Phase
white - Neutral
green - Protective Earth
STEEL GLAM ELECTRIC TOWEL WARMER - WALL MOUNTED
Make the electric connections of the towel warmer.
The connection should be made to a power supply of 120V/60Hz. Make a certied prossional
wire the towel warmer to the electrical circuit according to the gure.