Franck Dubarry Intrepidus Series User manual

user manual
intrepidus
43x50mm
Steel 316L
ISAswiss 8371
10atm/30atm
Sapphire

I II III
1
2
3
Setting the Time:
1
2
3
Pull out the crown to
position III (the watch stops).
Turn the crown until you
reach the correct time
Push the crown back into
position I.
Please note
In order to set the time to the exact
second, must be pulled out when the
second hand is in position «60».
Once the hour and minute hands have been
set, must be pushed back into position I
at the exact second.
1
3
I II
1
2
3
Setting the Date:
1
2
3
Pull out the crown to
position II (the watch
continues to run).
Turn the crown until the
correct date appears
Push the crown back into
position I.
Please note
The date can be changed during the date
changing phase between approx. 9:00 PM
and 12:00 PM; please note that the date must
be set to the date of the following day as in
this case the automatic date changing does
not occur at midnight.

1
2
3
Chronograph, basic functions
1
2
3
(Start / Stop / Reset)
Example:
Start: Press push-button A.
Stop: to stop the timing, press
push-button Aonce more and read
the chronograph counter (30mn)
Zero positioning (Reset) : Press
push-button B. (The chronograph hands
will be reset to their zero positions.)
A
B
Chronograph, Split Time
Please note
After two hours of continuous running, the
chrono stops and resets automatically to save
the battery.
1
4
5
2
3
A
B
1
2
3
4
5
Example:
Push-button A & B
Start: (start timing)
Display interval: (timing continues in the background)
Making up the measured time: (The chronograph
hands are quickly advanced to the ongoing measured time.)
Stop: (Final time is displayed)
Push-button B
Reset: The chronograph hands are returned
to their zero position
Please note
Following 3, further intervals or intermediates
can be displayed by pressing push-button B
(display interval / make up measured time, ...).
4

more informations at: www.franckdubarry.com