FREAKELECS DH-S1 User manual

DH-S1
FREAKELECS
USER GUIDE
By

Box Contents
1 - DH-S1 Padlock
1 - Micro-USB
Charging Cable
User Guide

Lock Technical Specs

Fingerprint Registration
Long press the preferred finger (finger
1 as in fig 1.2) that you want to set as
Administrator finger for over 10-
seconds until the blue light starts to
blink
Release the finger and press again the
same finger (finger 1). Repeat
releasing and pressing the finger
(finger 1) for over 10 times or until the
light steadily becomes green.
1.
2.
Setup 1st Fingerprint - Administrator
fig - 1.1
The lock is initially configured with factory settings. Hence, it
will unlock with any fingerprint until fingerprint registration is
complete.
3. When the green light becomes
steady, press and release another
finger (finger 2) repeatedly until the
long beep sound is heard and the
light goes off.
Admin fingerprint and alternate
fingerprints are registered.
Finger 1 is the admin. For
adding additional fingerprints,
administrator fingerprint
authentication is required. fig - 1.2

Setup Standard User Fingerprints -
Other Users
Long press the Admin finger (finger 1 as in fig 1.2) until the
green light turns on with beep sound.
Press and release the standard user finger (finger 3 as
shown in figure 1.2) repeatedly for 10-times or until the
green light goes off with long beep sound.
1.
2.
Now the standard user is successfully registered. Remember, now
that the fingerprints are set, the lock will unlock only when
unlocked using fingers 1,2,3 as in fig - 1.2 . Up to 10-fingerprints
are supported by this padlock.
Restore Factory Settings
Long press the Admin finger (finger 1 as in fig 1.2) until the
red light turns on.
Release and press the admin finger again. Once the red light
goes off, you may consider that the lock is reset.
1.
2.
Only admin finger could reset the lock to factory settings.
Low Battery Indication Alert
The red light keeps blinking continously
after you successfully unlock with the
registered fingerprint. However the lock
unlocks atleast 50-times during in its
minimum charge. The lock stays locked
even when it is out of charge.
Charging Options
Charge the lock using micro USB cable
provided. Insert the charging cable in to
the charging port. The light goes off once the lock is
completely charged. One full charge is most likey to last up
to 6-months.

Scan the QR Code to watch the demo
video.
C/O. MoonWalker
Workafella Sholinganallur, Rattha Group, Level 4, Tower A,
TEK Meadows, No 51, OMR, Sholinganallur, Chennai, Tamil
Nadu 600119
Contact # [phone]
Email Address: [email protected]