Freedom Charge FDMC-1280 User manual

INSTALLATION(INSTRUCTIONS
1280Instructions1-22-15.doc Page 1 of 3
2013 - Current KIA Forte Qi Wireless Charging Kit
(Kit # FDMC-1280)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Qi Wireless Charging Module with
Camry Specific Mat
Power Harness with 3 amp Fuse
These Instructions with Template
Removable Consumer Product Label
Plastic Trim Removal Tool
Phillips Screwdriver
Center Punch/Scribe Tool
Power Drill
1/2” Drill Bits
Wire Ties
Soldering Iron & Solder (Recommended)
Tape or Heat Shrink Electrical Tubing
*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit www.brandmotion.com for phone
compatibility guide.
Safety Precautions:
•Work in well ventilated area that is clear of obstructions.
•Secure vehicle with tire chucks in both front and rear of tires.
•Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•Wear safety goggles and snug fitting clothes.
•Use tools only for their intended purpose and which are in good repair.
•Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
For additional assistance please call Brandmotion Technical Assistance at [phone] then dial 2.
IMPORTANT: Do not place smart keys
within 15cm of charging mat. Vehicle
may not detect key to start vehicle. Do
not place metal objects in tray while
charging.

INSTALLATION(INSTRUCTIONS
1280Instructions1-22-15.doc Page 2 of 3
Step 1: Use a Phillips Screwdriver to remove
screw on side of console to gain access to the
12V ignition power point.
Step 2: Remove the rubber liner from bin
forward of shifter.
Step 3: Use provided template to mark 1/2"
drill location.
Step 4: Drill 1/2” hole in previous marked
location.
Step 5: Remove backing of adhesive pad.

INSTALLATION(INSTRUCTIONS
1280Instructions1-22-15.doc Page 3 of 3
Step 6: Insert connector of FreedomCharge
module through the 1/2" drill hole and firmly
press down.
Step 8: Splice wire of Power Harness to the
12v Switched Ignition wire of the power
point plug and the Ground wire to Black wire
of Power Harness.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
Step 9: Connect Power Harness to Charging
Module.
Step 10: Test system. LED light will
illuminate Blue once accessories are on.
Once Qi equipped device is placed on
Freedom Charge LED will illuminate Green
and charging begins.*Please note on some
devices syncing may take up to 15 seconds. Coil
locations vary on various devices; move device on
mat until LED illuminates green.
Step 11: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
Step 12: Place removable consumer product
label on center of mat.