FrightProps 0696 User manual
BEAM SENSOR
W ITH RELAY
When beam is broken WHITE and BLACK are contacted together completing a circuit and WHITE and GREY are opened (GREY is not normally
used). The Beam Sensor must have 12-30VDC supplied to the BROWN (+) and BLUE (-) wires.
OPERATION
INSTALLATION AND ADJUSTMENT
Adjust right/left
Adjust up/down
FEATURES
● Range: 13ft (4m)
● DC 12-30VDC
● Relay contact output: 250VAC 2.5A MAX.
● Light Source: Red LED
● Retroreflective
● Light ON operation
● Pre-wired 6-foot cord
● Bracket and mounting hardware included
● Adjustable sensing distance
● Compact size
This sensor requires
12vDC to operate. If the
device you will be using
it with does not supply
this voltage then you
will need to use a power
supply to power it.
COMM ON W IRING CONFIGURATIONS
W IRING DIAGRAM NOTES
● In all of these examples, swapping Grey for
Black will cause the circuit to be normally closed
instead of normally open.
●● Minimum distance from reflector is about 2ft.
Make sure reflector is installed at least that far
away. After positioning, adjustment of “SENS”
dial on top of unit is critical to successful
operation.
PICOBOO
BOOTUNES
BOOBOX FLEX
BOOTUNES AMPED BOOBOX
FLEX MAX
OTHER DEVICES
DIRECTLY TRIGGER
12vDC DEVICE
SIMPLE PROP TIMER
