STEP-V
Again, using a hammer, drive the remaining dowels to secure the BACK
STRETCHER to the END FRAMES as seen in the photograph.
STEP-VI
Carefully slide the BACK into place as
shown in the photograph. Secure the
BACK to the BACK STRETCHER by
using a proper screwdriver and the
wood screws provided. Cover the holes
with the teak plugs provided.
NOTE: USE OF A POWER SCREWDRIVER MAY STRIP THE WOOD, PLEASE USE A
HAND HELD SCREWDRIVER FOR STEP-VI.
STEP-VII
Tip the chair onto its front legs and secure the BACK to the SEAT with the
knock down bolts provided. Again, please use a proper screwdriver. A
power screwdriver or a drill with a screwdriver bit could cause damage to
the chair. DO NOT FORCE DOWELS FURTHER THAN THEY WANT
TO GO. Any protruding dowels, can easily be sanded away.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE
INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001