FrontRow JUNO ITR-01 Assembly instructions

ITR-01 Speaker Expansion Module
Installer Guide
Image 3
Image 1
Image 2
General Safety Precautions
• DisconnectallelectronicsfromtheJunoTowerduring
installationofthismodule
• Donotshortwiresbetweenspeakersandthismodule
• Donotinstallorusethemodulenearwaterorheatsources
• Protectallcablesfromwearanddamagefromstaples,foot
traffic,doors,andotherhazards
• UseonlyaccessoriesspecifiedbyFrontRow
• Referinstallationandservicetoqualifiedpersonnel
• Followallsafetyguidelineswhenusingladders
• Observeallapplicablebuilding,electrical,andfirecodeswhen
installinganyelectricalequipment
ESD Warning
TheJunoTowerand/orexpansionmodulescanbe
damagedbyelectrostaticdischarge(ESD).When
handling,caremustbetakensothatthedevicesare
notdamaged.Damageduetoinappropriatehandlingisnot
coveredbythewarranty.
Thefollowingprecautionsmustbetakenwheninstallingthe
expansionmodules:
• Useaconductivewriststrapattachedtoagoodearthground.
• AlwaysdisconnectthepowertotheJunofromthepoweroutlet.
• Alwaysdischargeyourselfbytouchingthegroundedbare
metalsurfaceorapprovedanti-staticmatbeforepickingup
anESD-sensitiveelectroniccomponent.
• Useananti-staticmattocoveryourworksurface.
You will need the following items to install this module:
• Enoughspeakerwiretoconnectbetweentheexternal
speakersandtheinstalledmodule.Besuretouse
plenum-ratedwireifitwillpassthroughaplenumspace.
• #1Phillipsandsmallslottedscrewdriver
Installation
1. UnplugtheJunoTowerfromthepoweroutlet
2. LaytheJunoTowerdownonaflatsurfacewiththebackofthe
Towerfacingup.Removethe8screwsthatattachthebackpanel
tothecasebackandremovethebackpanel(See Image 1 & 2)
3. LocatetheareaonthelowerPCBwherethemodulewillbe
installed(See Image 3)

821-5082-101/RevB1112
Installation - continued
 4. Removethemoduleandaccesspanelfromthepackaging.(See Image 4)
 5. Removeterminalblockfromthemodule.(See Image 5)
 6. Connectthe10pinsonthePageOverridemoduletothe10-pinconnectoronthemainTowerPCB.
Makesurethemoduleboardisseatedallthewaydown.(See Image 6)
 7. AttachtheboardtothemainTowerPCBusingthefourincludedscrews.(See Image 7)
 8. RemovetheaccesspanelcoverfromthebackpanelandreplacewiththeSpeakerExpansionmodule
accesspanel.(See Image 8 & 9)
 9. Replacethebackpanelandscrews.
10. Toconnectspeakers,refertotheJuno Installation guide
Image 4
Image 6 Image 7
Image 8 Image 9
Image 5