FSC MagClick 7143-34GY User manual

MagClick® Fast Wireless
Charging Desk Organizer
Instruction Manual
7143-34GY
1 x Desk Organizer
3 x Magnetic Dock
1 x Magnetic Foldable Accessory Holder
1 x Magnetic Card Holder
1 x Magnetic Pen Clip
1 x Magnetic Cable Clip
1 x Magnetic Phone Stand
1 x USB to Type-C Cable
1 x Instruction Manual
Type-C Input: 9V/2A
Wireless Output: 5W / 7.5W/ 10W
Wireless Charging Mobile phones and
other electronic devices:
Connect the provided Type-C cable to the
Type-C input port on the wireless charging
side of the desk organizer, then connect
the USB end of the cable to a power
source. LED indicator will flash red for 2
seconds then stay red when wireless
charging standby.
Place the wireless charging supported
device on the wireless charging surface(7),
using the MagClick® function. indicator will
glow blue in charging.
1.
•
•
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. LED Indicator
•
•
Magnetic Clip Board
Magnetic Dock
Magnetic Foldable Accessory Holder
Magnetic Card Holder
Magnetic Pen Clip
Magnetic Cable Clip
Fast Wireless Charging Surface
w/ Built-in MagClick®
Magnetic Phone Stand
Desk Organizer Stand
What’s included:
Functions:
Instructions:
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F(0°C) or above
115°F(45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above the
Do not use the device if damaged or
Do not disassemble the device. For
professional. incorrect reassembly may
or temperatures above 104°F may cause
explosion.
use only identical replacement parts to
ensure product safety.
Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove any attachments from the
phone before charging on this device,
attachments can interfer with wireless
charging and lead to over heating.
•
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
SAFETY PRECAUTIONS:
If the device does not support MagClick®:
Using the magnetic phone stand(8) adjust
the device to the required height, phone
will begin to charge automatically once
placed in the correct location.
Once fully charged remove the device.
Note: When wireless charging, if the LED
indicator flashes blue the device is either
NOT a wireless charging device or there is
an object between the device and charging
surface interfering with the charging.
process.
•
•
•
**
Magnetic Accessories2.
Using appropriate accessory to DIY/organize
your belongings.
•
13 The strong magnetic fields of neodymium
magnets can damage items such as
television, computer monitors, credit cards,
bank cards, computers, diskettes and other
data carriers, video tapes, mechanical
MADE IN CHINA
watches, hearing aids, loud speakers and
VCRs. Pace-makers may be damaged or
switch to "Test Mode" in the presence of a
strong magnetic force, if a pace-maker or
other electrical body implant is in use, keep
a minimum of 3 feet distance.
21.4 mm
31.5 mm
2.8 mm
165.1*94mm

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. During the operation of device
a distance of 15 cm surrounding the device and 20 cm above the top surface of
the device must be respected.
FCC statement: