Twist the screw top off the
cartridge.
Screw in the cartridge up to the
stopline. Operate the press until
lubricantappears at the end of
the armoured pipe (3–5 strokes).
Now the press is ready to use.
The pumpunit is relled by vacuum
after eachstroke.
Depending on how the cartridge
was lled, a small quantity of air
may betrapped in the area of the
screw thread.
Gently press the centre of the
piston topush out this air in order
to ensure thatthe lubricant reaches
the pump unitimmediately.
At each stroke,you should open
thepress smoothly and keep it open
for aslong as it takes, to ll the pump
unitagain. Depending on the tempera-
tureand type of lubricant used, it may
takeup to three seconds for the piston
chamber to be lled completely.
When you start to feel resistance clos-
ing the hand lever, this indicates the
chamber contains the right amountof
lubricant.
Attach the armoured pipe* to the
press head. This grease gun allows
amaximum pressure of 400 bar.
WARNING! Check the lubricating
channels, grease nipples and the
pointsof lubrication before you start
operatingthe press with both hands.
You can check the level of lubricant
inthe cartridge at any time (see
diagram). The special piston shape
ensures that the cartridge is being
completely emptied.
*) Minimum permissible bending radius: 100 mm; permissible dynamic operating pressure: 400 bar
How to use the SYSTEM REINER
two-handed CASSIDA HD Grease Gun
General instructions for use
• Before starting lubrication:
Ensure that the grease nipple and the grip coupling are
clean.
• During lubrication:
The grip coupling/armoured pipe must sit upright on
the nipple. If you hold the grip coupling at an angle, the
nipple is not fully covered. Keep checking the amount of
lubricant being extruded.
• After lubrication:
Do not pull the mouthpiece/grip coupling off the nipple,
but bend it sideways. Nipples which do not work properly
must be replaced as soon as possible.
Important safety information
Our SYSTEM REINER CASSIDA HD GREASE GUN carries the
GS label, which means it has been checked for safety.
It is designed to operate at pressures of 400 bar, in accordance
with DIN 1283, and has a large built-in safety margin.
The design of thegrease gun means it requires less operating
force than conventionalgrease guns.
Art 58 / 2017-08
