Mo-Clamp 2450 User manual

Specifications:
Overall length: 0" (000 mm)
Weight: 0 lbs (00 kg)
Capacity: 00 tons (0,000 kg)
6920 SW 111th Avenue, Beaverton, OR 97008 USA
1-800-678-5548 • [phone] • Fax [phone]
www.moclamp.com email: [email protected]
©Pull-It Corporation
#2450 Boltless Strut
Tower Puller
Boltless
Strut Tower Puller
100% Made in U.S.A.
Since many automobile shock towers are
manufactured without bolts, they present a
special problem for the auto body professional.
How can a multi-directional
puller be securely attached?
Before removing the strut, it is recommended
that the amount and direction of the necessary
correction be measured.
NOTE: Use in conjunction with your chassis
dimension and specification charts.
Before pulling, center-punch one or two marks
close to the tower plate. Use these center-punch
marks as reference points to indicate the
amount of pull needed.
Installation instructions:
Remove strut from tower area.
Insert come up through bottom of tower.
Install cap, side pull attachment, and eye nut.
Position side pull attachment in direction of
pull and tighten eye nut.

Specifications:
Overall length: 0" (000 mm)
Weight: 0 lbs (00 kg)
Capacity: 00 tons (0,000 kg)
6920 SW 111th Avenue, Beaverton, OR 97008 USA
1-800-678-5548 • [phone] • Fax [phone]
www.moclamp.com email: [email protected]
©Pull-It Corporation
#2100
Designed for 95% for the various
strut tower bolt patterns.
Original design.
Other
Strut Tower
(with bolts)
Adapter Plates
100% Made in U.S.A.
#2400
Designed for a wider variety of
McPherson strut towers.
The 2400 is more versatile.
Specifications:
Overall length: 0" (000 mm)
Weight: 0 lbs (00 kg)
Capacity: 00 tons (0,000 kg)