Fujitsu fi 5750C - Document Scanner Configuration guide

BEFORE CLEANING
Open the ADF by pressing the
buttons on the cover
Consumables Part Number
Pick Roller PA03338-K011
Brake Roller PA03338-K010
Cleaning Materials SC-CLE-KIT2
Note: Please ensure Cleaner F2 is NOT used on
Rubber Rollers
Paper
Chute
ADF
Cover
Cover Open
Buttons
2
3
4
1Brake Roller
Open the brake roller holder and remove the brake roller, before cleaning.
ADF Glass Surfaces x 2
Located on the ADF cover and opposite side. Clean lightly.
Remove the ADF Paper Chute and lift the Pick Roller Cover. Remove the rollers and
clean lightly taking care not to scratch the surface.
Pick Roller x 2
Clean lightly while rotating with your finger. Take care not to roughen the surface.
Plastic Rollers x 4
Turn the Scanner OFF while cleaning the following locations
It is recommended that these items be
cleaned EVERY 10,000 SCANS
Using cleaning paper moistened with F1 Cleaner
Cleaning Instructions for
fi-5750C Flatbed Scanner
P.T.O.
Open the document cover clean:
Cleaning the Flatbed
Using cleaning paper
moistened with F1 Cleaner
1
2
Document Holding Pad
Document Bed
1
2
23
4
1
5Brake Roller
Plastic
Rollers
Pick Rollers
Feed Rollers
Glass Eject Rollers (hidden)
6

2
3
4
1
5
Brake Roller
Plastic
Rollers
Pick Rollers
Feed Rollers
Glass Eject Rollers (hidden)
6
To rotate the Feed and Eject Rollers, press the POWER button while holding down the
SCAN button.
As a guideline, seven presses of the POWER button make the rollers rotate one full turn.
6
5Clean lightly taking care not to roughen the surface.
Feed Rollers x 2
Turn the Scanner ON while cleaning the following locations
Clean lightly taking care not to roughen the surface.
Eject Rollers x 2
Using cleaning paper moistened with F1 Cleaner
For further information please refer to the
fi-5750C Flatbed Scanner Operators Guide
which can be found on our Website:
www.fel.fujitsu.com/scanner
January 2007
Cleaning Instructions for fi-5750CFujitsu Europe LImited
While holding down the SCAN button
Press the POWER button
1
2
1
2
Each press of the POWER button will cause
the rollers to rotate