Furinno 11161 User manual

MODEL: 11161
NO-TOOL 2 DRAWERS CHEST
Rev : 01

BEFORE YOU BEGIN, PLEASE READ ASSEMBLY INSTRUCTIONS CAREFULLY.
FOLLOW THEM STEP BY STEP.
CAUTION:
1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS.
CARE SHOULD BE TAKEN IN THE UNPACKING AND ASSEMBLY OF THE PRODUCT.
2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO THE PRODUCT FINISH.
3. MAKE SURE ALL PARTS ARE INCLUDED BEFORE ASSEMBLY.

ASSEMBLY INSTRUCTION
STEP 1
INSERT DOWEL (1) TO THE PRE-DRILLED HOLES OF PANEL (B)(C)(D)(E).
STEP 2
FIX LOCK SWITCH (5) INTO THE CAM LOCK OF EVERY PANELS, BEFORE ASSEMBLY THE UNIT.

STEP 3
ATTACH PANEL (E) TO PANEL (B).
STEP 4
ATTACH PANEL (D) TO PANEL (B).
TURN ON CAM LOCK AND FIX INTO THE PRE-DRILLED NUT.
TURN OFF CAM LOCK WHEN THE PANEL WERE FIXED.

STEP 5
ATTACH PANEL (C) TO PANEL (D)(E).
REPEAT THE SAME METHOD AS STEP 4.
STEP 6
UPRIGHT THE UNIT. ATTACH PANEL (A) TO IT.
REPEAT THE SAME METHOD AS STEP 4.
STEP 7
INSERT PLASTIC PIN & NUT (3) INTO THE FOUR CORNER OF PRE-DRILLED HOLES ON PANEL (F).
INSERT PLASTIC STOPPER (2) INTO THE BALANCE OF PRE-HOLES ON PANEL (F).
***(THOSE ARE SHOWN WITH TRIANGLE MARKING)***

STEP 11
SLIDE 2 NOS. OF DRAWER INTO TH UNIT.
INSERT RUNNER STOPPER (6) TO THE PRE-
DRILLED HOLE OF DRAWER SIDE PANEL (H)(I),
AS SHOWN.
STEP 8
ATTACH PANEL (J) TO PANEL (H)(I).
REPEAT THE SAME METHOD AS STEP 3.
STEP 9
SLOT IN PANEL (K) TO PANEL (H)(I), AS SHOWN.
ATTACH PANEL (G) TO THE ASSEMBLED SECTION.
REPEAT THE SAME METHOD AS STEP 3.
STEP 10
FIX THE HANDLE SET (4) TO THE PANEL (G).
Date: 1.10.2014