Furinno 11222 User manual

MODEL: 11222
NO-TOOL 2 DOOR WARDROBE
Rev: 01

BEFORE YOU BEGIN, PLEASE READ
ASSEMBLY INSTRUCTIONS CAREFULLY.
FOLLOW THEM STEP BY STEP.
CAUTION:
1. ADULT SUPERVISION IS REQUIRED
DUE TO SMALL PARTS.
CARE SHOULD BE TAKEN IN THE
UNPACKING AND ASSEMBLY OF
THE PRODUCT.
2. ASSEMBLE ON SOFT SURFACES TO
PREVENT DAMAGE TO THE
PRODUCT FINISH.
3. MAKE SURE ALL PARTS ARE
INCLUDED BEFORE ASSEMBLY.

ASSEMBLY INSTRUCTION
STEP 1
INSERT DOWEL (1) INTO THE PRE-HOLES ON PANEL (D), (F) AND (G).
STEP 2
INSERT MAGNECTIC CATCHES (2) INTO THE PRE-HOLES ON PANEL (A) & (D).
STEP 3
ATTACH PANEL (G) & (F) TO PANEL (B).
TURN ON CAM LOCK AND FIX INTO THE
PRE-DRILL NUT.
TURN OFF CAM LOCK WHEN THE PANEL
WERE FIXED.

STEP 5
ATTACH PANEL (C) TO ASSEMBLED UNIT.
REPEAT THE SAME METHOD AS STEP 3.
STEP 4
ATTACH PANEL (D) TO PANEL (B).
REPEAT THE SAME METHOD AS STEP 3.

STEP 6
ATTACH PANEL (A) TO ASSEMBLED UNIT.
REPEAT THE SAME METHOD AS STEP 3.
STEP 7
FACE DOWN THE UNIT AND ATTACH PANEL (H).
INSERT PLASTIC PIN & NUT (6) INTO THE PRE-HOLES OF PANEL (H).
(6) x 8sets

STEP 9
UPRIGHT THE UNIT.
FIX PANEL (E) TO PANEL (B) & (C) WITH HINGE PIN (5).
STEP 8
INSERT PLASTIC STOPPER (7) INTO THE BALANCE OF PRE-DRILLED HOLES OF PANEL (H).

Date: 29.9.2014
STEP 10
INSTALL HANDLE SET (3) TO PANEL (E).
PLACE THE HANGING RAIL (4) ON THE HOLDER.
This unit is intended for use only with the
products and maximum weights
indicated. Use with other products or
products heavier than the maximum
weights indicated may result in instability
causing possible injury. Furniture can tip
over or break if improperly moved. Have
a friend help to lift and carry the unit to
it's new location.